Smart One
English
Quick Reference Guide
Smart One
Pocket Spirometer
Rev.1
Quick Reference Guide
Page 1 of 7
Smart One
English
Intended Use
The MIR Smart One spirometer is intended to be used as an over-the-counter device by a
patient under the prescribed use of a physician. The equipment is intended to test lung
function and can perform tests in adult and pediatric patients greater than 5 years.
The Smart One spirometer has been designed for use directly by the patient to monitor her/
his physical conditions at home.
Warnings
A more complete listing of warnings are found in the Instructions for use.
The disposable turbine is made of plastic with paper mouthpiece and its disposal after use
should adhere to the local regulations and norms in force.
The accuracy of the reusable turbine can only be guaranteed if it has been cleaned in the
correct manner and is free from foreign bodies. Weekly cleaning should only be
done when the equipment is for personal use and will only be used by one patient. The
cleaning of the turbine should be performed according to the instructions contained in
this User’s Manual.
Welcome
Under the care of your physician, you have purchased the MIR Smart One for
your home use. The tests you complete will help you and your physician see how well
your lungs function.
We are here to help
If you have any difficulty completing a test, call your physician for assistance.
If the Smart One does not work properly, call the MIR help line at 1-262-565-6797
Please make sure that the turbine is all the way in and twisted to the right in the locked
position and that the batteries are tested before use.
Rev.1
Quick Reference Guide
Page 2 of 7
Smart One
English
Let’s get started
Preparing your MIR Smart One
Your Smart One already comes assembled. All
you need to do is install the batteries.
Download the Smart One App
Select camera app
Take picture of QR Code
Download app
Requires iOS 11.0 or later
Requires Android 5.0 or later
Rev.1
Quick Reference Guide
Page 3 of 7
Smart One
English
First setup
Connect to Smart One
Enter your information
<=
Press the
hamburger
menu button
in the top-left
Physically tap the
serial number with
your finger to sync
your device
Turbine choice
Make sure that the Smart One is provided
with the orange turbine and is twisted to the
right in the locked position.
Additional replacement turbines and
mouthpieces are available for purchase.
Rev.1
Quick Reference Guide
Page 4 of 7
Smart One
English
Spirometry Peak Flow/FEV1 Test
Test is best done while standing or sitting still.
Carefully follow the indications provided by the App before starting.
Select Start Test
on Home Screen
Blow properly
Flow bar appears
during test
Test results
Switching The Difficulty
Tests can be given an easier or more difficult setting based on the
needs of the patient.
Press the +/- symbol at the
top-right of the screen once
the test is open
Rev.1
Choose the correct
difficulty setting for
the patient who is
testing
Quick Reference Guide
Page 5 of 7
Smart One
English
View your data
Go to results list
List of results
See a set of results
Note: Refer to the Smart One manual for more information about the measurements
Send a result to your physician
You can send a report to your physician from your Smartphone.
The spirometry results can then be analyzed by a clinician and findings will follow.
List of results
View data
Send report to physician
MIR Smart One application shows the user all App available on the Smartphone to share
the reports with your physician.
Rev.1
Quick Reference Guide
Page 6 of 7
Smart One
English
Cleaning
1. Rotate the turbine and mouthpiece
counterclockwise to separate it from
handheld unit
2. Mix ¾ cup of Clorox™ bleach (7.5%) in one
quart of water.
Place turbine in solution
Place mouthpiece in warm water
3. Shake the turbine so as to remove any
impurities for at least 1 minute and the
mouthpiece for 2-3 minutes
4. Leave the turbine and the mouthpiece
immersed for 15 minutes.
5. Rinse turbine and mouthpiece in clean
water for 1 minute
Warning. Do not place turbine in running
water. It may damage the unit
6. Shake off the excess water from the
turbine and let it dry. Position the turbine
and the mouthpiece vertically on a dry
surface.
Clean the electronic unit with a damp cloth from the same Clorox dilution.
DO NOT SUBMERGE THE DEVICE. Let the device dry, then clean the device with a damp
cloth.
List of Cautions and icons: A complete set of cautions and icons are found in the Smart One
manual.
Rev.1
Quick Reference Guide
Page 7 of 7
">
