TTK_EUROGRD_FOG_LIGHT.qxp_Layout 1 1/6/16 11:22 AM Page 1
T ACTIK
®
Factory
Fog Light Euro-Guards
Installation Manual: for ’07-Current Jeep Wrangler JK
# 13117.0114 and # 13117.0104
PARTS LIST:
Fog Light Euro Guards - QTY 2
O-Rings - QTY 2
REQUIRED TOOLS:
Safety Glasses
Phillips Head Screwdriver
READ ALL SAFETY MESSAGES AND UNDERSTAND ALL
INSTRUCTIONS BEFORE ATTEMPTING TO INSTALL THIS
PRODUCT. ALWAYS WEAR SAFETY GLASSES DURING INSTALL.
Complete Euro Guard Installation:
If you plan on installing our complete set of front Euro Guards (Headlights,
Turn Signals, Fog Lamps and Side
Markers) all at once, we recommend doing it in the following order:
1. Headlight Guards
2. Turn Signal Guards
3. Fog Lamp Guards
4. Side Marker Light Guards
Each item will come with instructions.
3
1
2
4
TTK_EUROGRD_FOG_LIGHT.qxp_Layout 1 1/6/16 11:22 AM Page 2
Step One: Remove Air Dam & Fog Light Housing
Figure 1
Figure 3
Figure 2
Put on safety glasses. For easy access to the Fog Light housings, remove the factory plastic air dam. Start by unscrewing the plastic phillips head screws and removing plastic rivets. These are located on the underside of bumper and backside of crossmember as shown in figures 1 & 2. Remove air dam and save all screws & rivets for reinstallation.
Removing the Fog Light:
Starting with the Driver’s Side, Locate the back of the driver side Fog light by looking under your vehicle on the back of the bumper (Fig 3). On the back of the Fog lamp housing are four (4)
Phillips head screws that secure the housing to the bumper.
From under the vehicle, remove these screws using a Phillips head screw driver (fig 3) and set them aside in a safe place for re-installation.
2
TTK_EUROGRD_FOG_LIGHT.qxp_Layout 1 1/6/16 11:22 AM Page 3
Step Two: Install Fog Light Euro Guards
Figure 4
Place/install the enclosed O-Rings on the outside of the Euro-Guard as shown in Fig 4. The O-Ring should be on the face of the Euro Guard that will be in contact with the bumper housing.
Figure 6
From under the vehicle, place the driver’s side Euro-Guard into the Fog lamp opening on the back side of the bumper. The Bars on the Euro-Guard should be in the vertical position (Fig 5).
Figure 7
A helper can be handy to hold the
Euro-Guard in place (Fig 7), Carefully re-install the Fog Lamp housing into the bumper using the original Phillips head screws. Snug the screws (Fig 8) and the
Figure 8
Euro-Guard will be held in position between the light housing and the bumper itself. With driver side now complete, please repeat all steps for the passenger side Fog Light Euro-Guard.
3
TTK_EUROGRD_FOG_LIGHT.qxp_Layout 1 1/6/16 11:22 AM Page 4
ALWAYS CHECK TURN SIGNAL AND LIGHTS FUNCTION BEFORE
DRIVING AFTER EURO - GUARD INSTALLATION.
At this point the Fog Light Euro-Guards are installed. After installing any other nearby Euro-Guards, re-install the
Plastic factory Air Dam.
Care and Maintenance:
Your Euro-Guards have been designed and manufactured to provide years of use. However, like any product general maintenance is required to keep them looking new. Since the Euro-Guard is located on the front of the vehicle, it is subject to potential rock chips and other debris potentially causing portions of the paint to chip off.
For Textured Finish Euro-Guards:
We recommend using a textured spray paint sprayed on a piece of cardboard and Q-Tip to gently fill in these chips.
This will prevent any rust from forming.
For Bright Finish Euro-Guards:
To protect your bright finish
Euro-Guards we recommend using a car wax on the parts on a regular basis.
This will protect the finish and keep your Euro-Guards looking like new.
TACTIK ® Exclusive Three Year
Limited Warranty:
Please see separate Warranty Card insert for full details regarding the
TACTIK ® Exclusive Three Year
Limited Warranty.
© TACTIK ® 2016. All Rights Reserved.
1.5.16 LTR Version
Instruction Booklet # 12999.3011
4
TACTIK_3YR_WAR_LTR.qxp_QLIFT 1/5/16 1:26 PM Page 1
TACTIK ® Exclusive
Three Year Limited Warranty
Your TACTIK ® branded accessories are covered by the following Limited Warranty provided exclusively by the TACTIK ® Division of
Quadratec, Inc. 1028 Saunders Lane,
West Chester PA 19380.
This Limited Warranty is the only warranty made in connection with your purchase.
TACTIK ® neither assumes nor authorizes any vendor, retailer or other person or entity to assume for it any other obligation or liability in connection with this product or Limited
Warranty.
What is Covered: Subject to the terms, exclusions and limitations herein and with respect only to TACTIK ® branded accessories first sold in the United States, TACTIK ® warrants to the initial retail purchaser only that your TACTIK ® accessory shall be free of defects in material and workmanship: for a period of three (3) years from date of retail purchase.
This Limited Warranty is not assignable and shall terminate upon sale of the vehicle upon which the TACTIK ® accessory is installed or other transfer third persons.
All other warranties are hereby disclaimed, except to the extent prohibited by applicable law in which case any implied warranty of merchantability or fitness for a particular purpose on this product is limited to 3 year from date of initial retail sale. TACTIK ® reserves the rights to: (a.) require invoice or other proof your accessory is within the terms of this
Limited Warranty as a condition of warranty service and, (b.) make future revisions to this product and Limited Warranty without prior notice or obligation to upgrade your product.
What is Not Covered:
Your TACTIK ™ Limited Warranty does not cover products or parts TACTIK ® determines to have been damaged by or subjected to:
(a.) installation damage, alteration, modification, combination with other parts, failure to maintain or improper repair or service, (b.) normal wear & tear, cosmetic damage or damage from moisture or water immersion, (c.) Acts of
God, accidents, misuse, negligence, inadequate mounting or impact with vehicle(s), obstacles or other aspects of the environment, (d.) theft, vandalism or other intentional damage.
Remedy Limited to Repair/Replacement:
The exclusive remedy provided hereunder shall, upon TACTIK ® inspection and at
TACTIK’s option, be either repair or replacement of product or parts (new or refurbished) covered under this Limited Warranty.
Customers requesting warranty consideration should first contact TACTIK ® to obtain a RGA number (610-701-3336). All labor, removal, shipping and installation costs are customer’s responsibility.
Other Limitations - Exclusion of Damages -
Your Rights Under State Law:
In consideration of the purchase price paid, neither TACTIK
TACTIK ®
® nor any independent distributor/licensee are responsible for any time loss, rental costs, or for any incidental, consequential, punitive or other damages you may have or incur in connection with any part or product purchased. Your exclusive remedy hereunder for covered parts is repair/replacement as described above.
This Limited Warranty gives you specific rights.
You may also have other rights that vary from state to state. For example, some states do not allow limitations of how long an implied warranty lasts and /or do not allow the exclusion or limitation of incidental or consequential damages, so the limitations and exclusions herein may not apply to you.
© TACTIK ® 2016. All Rights Reserved.
LTR Version
01052016132654
