Crown Automotive 12V 12 Volt Wiper Conversion Kit (Manual to Vacuum) Top Mounted Installation Instructions
Advertisement
Advertisement
WIPER MOTOR KIT INSTALLATION INSTRUCTIONS
19101.03 (12V-ST)12 Volt Stainless Steel
19101.02 (12V) 12 Volt Kit - Black
19101.04 (24V) 24 Volt Kit – Black
Installation Notes :
The ( S ) terminal should be connected to one side
of the control switch. The other lead wire from the
switch will need to be grounded.
The ( – ) terminal should be connected to a good
ground on the vehicle chassis or to the battery’s
negative terminal.
The ( + ) terminal should be connected to the original
fused wiper motor wire or fused battery positive
wire. Use a 10 amp fuse if a new wire assemble is
to be used.
REV 01/10 SB

Public link updated
The public link to your chat has been updated.
Advertisement