Teraflex 001902000 Third Brake Light Extension Kit Installation Instructions
Advertisement
Advertisement
Installation Guide for the TJ
Brake Light Extension Kit
Part #1902000
1. Remove the spare tire.
5. Connect the brake light tower to the top of the extension plate using the included hardware. Be sure to use a washer on both the top and bottom of the bolt.
Tera Manufacturing, Inc.
5251 South Commerce Dr.
Murray, Utah 84107
Phone/801.288.2585
Fax/801.713.2313
www.teraflex.biz
2. Release brake light wiring from retention clips to allow for extended length. Remove the bolts on the bottom of the brake light tower.
3. Place the brake light extension plate between rear tire mount and the brake light tower. The lower left side of the extension plate should match the contour of the rear tire mount.
6. Reinstall spare tire. (33-inch tire shown.)
NOTE:
On the TJ Rubicon edition
Wrangler, there is a factory spacer on the brake light mount that can be removed when installing the brake light extension kit.
4. Attach the bottom of the brake light extension plate to the tire
mount using the bolts removed in Step 1.
Revised 28 May 08

Public link updated
The public link to your chat has been updated.
Advertisement