Mounting an Ellipse bracket on a Dell Vostro 360 Computer

Mounting an Ellipse bracket on a Dell Vostro 360 Computer
Mounting an Ellipse bracket on a Dell Vostro 360 Computer
Lay the computer on its face
Remove 6 screws as indicated by the blue arrows.
Remove the screws with a phillips head screwdriver.
Mounting an Ellipse bracket on a Dell Vostro 360 Computer
Remove the Dell cover from the back of the computer.
Note: It snaps off and on.
Remove the 2 screws holding the Dell kickstand in place.
(Located on the right and left.)
Mounting an Ellipse bracket on a Dell Vostro 360 Computer
Slide the bracket down towards the bottom
of the computer and lift it up.
Replace the kickstand bracket with the one from the
Ellipse system. Use the 2 screws that you removed
from the left and right side of the other bracket.
Now reconnect the Dell cover onto the computer. Also
replace the 6 screws that hold the back plate in place.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement