SLB-046 INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS
SLB-046 HANGER BRACKET
for Boxlight SP-46d, XP-56d, Enthronic E951, E951X,
Prior to assembly, unpack carton and verify contents.
For security installation, use security hardware package inside the ALL-POINTS™
Security Kit. Follow the instructions below for attaching the bracket to the projector
using either standard hardware or security hardware.
If you are missing any of the following components, please contact Customer Service at
1-800-582-6480
(1)
(4)
(3)
SLB-046 Bracket
10 - 24 Thumb Nuts
1/2" x .219 x 1/4" Nylon Spacer
(3)
(3)
M3 -12mm Philips Pan Screws
M3 Flatwasher
INSTALLATION INSTRUCTIONS
1.
Turn projector upside down.
2.
Place the three ¼” nylon spacers over the three threaded inserts in the bottom of the
projector.
3.
Place the SLB-046 bracket onto the three ¼” nylon spacers on the bottom of the projector
lining up the three mounting holes in the bracket with the three nylon spacers.
4.
Using the three M3 x 12mm screws start them into the three threaded inserts and tighten
all fasteners at this time, securing the bracket to the projector. CAUTION: When
attaching the mount be careful not to overtighten screws.
5.
See RPA and/or Smart-Lift™ Instructions.
8802-000091
CHIEF MANUFACTURING INC. 1-800-582-6480, Fax: 1-877-894-6918, Email: chief@chiefmfg.com
10/28/03