RTA1335 Spec Sheet

ADSL2+ 4-Port Modem Router
4 Ethernet Ports with Security Firewall
RTA1335
FEATURES
>
Broadband Internet Access up to 24 Mbps
>
Supports ADSL, ADSL2 and ADSL2+
>
Simple Configuration
>
4 Ethernet Ports for Internet Sharing
>
Suitable for Home and Office Networks
>
Security Firewall & DMZ
>
VPN Pass-through
>
Port Forwarding, UPnP™ and QoS
>
Freecall Helpline
NZ 0800 653 962
AUS 1800 063 962
12 month
warranty
www.dynalink.co.nz
www.dynalink.com.au
Get Connected.
4 Ethernet Ports with Security Firewall
Technical Specifications (RTA1335)
ADSL Compliance
Routing
ADSL
• ANSI T1.413 Issue 2
• NAT / PAT allows multiple users to share Internet
access
• ITU G.992.1 Annex A (G.dmt)
• UPnP IGD with NAT traversal capability
• ITU G.992.2 Annex A (G.lite)
• ITU G.994.1 (G.hs)
• Port Forwarding: users can setup multiple virtual
servers (e.g., Web, FTP, Mail servers) on the local
network.
• Support dying gasp
• Static routing & dynamic routing RIPv1/v2
• Maximum Rate: 8 Mbps downstream and
1 Mbps upstream
• DNS Relay, Dynamic DNS
ADSL2
• DHCP Client/Relay/Server
• IGMP Proxy
• ITU G.992.3 Annex A (G.dmt)
• ITU G.992.4 Annex A (G.lite)
• Maximum Rate: 12 Mbps downstream and
1 Mbps upstream
ADSL2+
• Support IP/Bridge QoS for different traffic classes
• Support reservation of bandwidth to guarantee
voice quality of VoIP applications.
Security
• ITU G.992.5 Annex A (G.dmt)
• Maximum Rate: 24 Mbps downstream and
1.2 Mbps upstream
• PAP, CHAP, and MS-CHAP for PPP authentication
• Firewall based on incoming & outgoing filtering
of IP address/Port number/Protocol type
• Ping blocking from WAN
ATM
• DMZ hosting
• PPPoA (RFC 2364) and PPPoA Bridged mode
• PPPoE (RFC 2516) and PPPoE Bridged mode
• IPoA (RFC 2225)
• Bridged mode over AAL5 (RFC2684/1483)
• ATM Forum UNI 3.1 / 4.0 compliant PVCs
• UBR and CBR with traffic shaping
• OAM F4/F5 loopback cells
Supported Applications
• Application Level Gateways preset for Auth/Ident,
DNS, FTP, PPTP, IPSEC, POP3, SMTP, SSH, TELNET,
TFTP & WEB servers. Multiple Virtual Servers can
be setup in local network.
• VPN passthrough
• NetMeeting, MSN Messenger, FTP, Quick Time,
mIRC, Real Player, CuSeeMe, online gaming.
Bridging
• IEEE802.1d self-learning bridge
• Learning up to 4096 MAC addresses
• Transparent Bridging among Ethernet ports
Configuration and Management
• Embedded web configuration interface with
password protection
• Remote management control
• Telnet session for local or remote management
• System events logging
• DSL connection diagnostics
• Firmware upgrade via web browser
• User setting backup & restore
www.dynalink.co.nz
www.dynalink.com.au
4 Ethernet Ports with Security Firewall
Technical Specifications (RTA1335)
Hardware Interface
• One RJ-11 port for ADSL connection
• Four Ethernet ports for IEEE 802.3/802.3u 10/100
Base-T auto-sensing, auto cross-over
• One hidden reset button for restoring factory
default settings
Chipset
• Broadcom BCM6338 single-chip ADSL2+ with
integrated MIPS32 CPU, transceiver & Analog
Front End.
Regulatory Approval and Compliance
• ACA
• Telecom New Zealand PTC270
Power Requirement and Operation
Environment Requirement
• Power Adaptor: Output 12 VAC, 1A
• Power Consumption: less than 10 W
• Ambient Temperature: 0 to 40°C
• Relative Humidity: 20% to 90% (non-condensing)
Physical
• Front Panel: 7 LED Indicators
• Rear Panel
• Dimensions: 165mm(L) x 120mm(W) x 42mm(H)
• Weight: 300g
www.dynalink.co.nz
www.dynalink.com.au