9762 Owners Manual

9762 Owners Manual
TREMOLO EFFECT
INSTRUCTIONS
● PLEASE READ THESE INSTRUCTIONS CAREFULLY FOR PROPER OPERATING PROCEDURES
http://www.monstereffects.com
REV–A01
INTRODUCTION
Thank you for purchasing your new
Monster Effects Swamp-Thang tremolo
effect pedal! It is designed to replicate the
classic tremolo effect found in many
vintage tube amplifiers.
Before operating or installing the unit,
please read this manual thoroughly and
retain it for future reference. Additional
copies of this manual are available on our
website at http://www.monstereffects.com.
AC-ADAPTER
JACK
TREMOLO
DEPTH
TREMOLO
SPEED
ACTIVE
LED
INPUT
JACK
OUTPUT
JACK
BYPASS
SWITCH
TREMOLO SPEED
INPUT JACK
The speed control determines the rate of the
tremolo effect. Clockwise rotation increases the
effect rate while counter-clockwise rotation
decreases the effect rate.
The instrument input jack accepts signals from
instruments or other effects. Avoid overdriving
the input for best effect sound.
TREMOLO DEPTH
The depth control determines the depth of the
tremolo effect amplitude modulation. Clockwise
rotation increases the effect depth while counterclockwise reduces the effect depth.
BYPASS SWITCH
Swamp-Thang uses true bypass switching. The
pedal bypass switch engages or bypasses the
effect.
ACTIVE LED
The LED lights when the effect is active. The
LED flashes at the rate set by the SPEED
control to provide visual speed indication.
OUTPUT JACK
The output jack is intended to drive an amplifier
or other effect input. Note that power is enabled
to the unit whenever a plug is inserted in the
output jack. Always remove any plug from the
output jack to preserve battery life when the unit
is not in use.
AC ADAPTER JACK
The Swamp-Thang operates from 9V battery or
external AC adapters providing 9-12V of clean
DC power. The adapter jack accepts tip plugs
with either plus(+) or minus(-) tip polarity
automatically.
1
OPERATION
If you plan to operate the Swamp-Thang from a
battery you must first install a new battery.
Remove the rear cover by removing the four
cover screws and connect a new 9V battery to
the battery clip. Seat the battery inside the unit,
replace the rear cover and reinstall the screws.
Connect the Swamp-Thang as shown in the
diagram below.
BATTERY OPERATION
Note that battery power is enabled to the unit
whenever a plug is inserted in the output jack.
Always remove any plug from the output jack to
preserve battery power when the unit is not in
use. Remove or replace any dead or aging
battery from the unit to prevent corrosive
damage from a leaky battery.
AMPLIFIER
AC ADAPTER OPERATION
The Swamp-Thang will operate from most any
AC power adapters providing 9-12VDC of clean
power. The external power jack accepts plug
tips with either plus(+) or minus(-) tip polarity.
Automatic polarity detection circuitry prevents
damage and allows use with most any 9V DC
power adapter. Additionally, internal power
filtering and regulation circuitry assures super
quiet operation.
BASIC USE
Toggle the pedal BYPASS switch to enable or
bypass the effect. The rate indicator will flash
when the effect is enabled at the rate set by
SPEED control. Adjust the DEPTH and SPEED
controls to personal preference. If the LED
becomes weak or the sound weakens or distorts
please check and replace the battery.
9-12V DC
AC ADAPTER
TO
INSTRUMENT
2
SPECIFICATIONS
Power......................................................Battery DC 9V, AC Adapter DC 9-12V
Current Draw .........................................DC9V, 10mA
Controls..................................................Speed, Depth, Bypass
Jacks ......................................................Input, Output, AC Adapter
Input Impedance....................................47KΩ
Output load impedance ........................Over 10KΩ
Dimensions............................................4.39(L) x 2.34(W) x1.6”(H)
Weight ....................................................200g
• All specifications subject to change without notice.
3
LIMITED WARRANTY
Monster Effects warrants this product to be free of defects in material and workmanship for a period of 1
year. Positive proof of purchase is required in the form of the original sales receipt or invoice for all
warranty repair returns.
To request warranty service, the owner must call or contact Monster Effects in writing to obtain return
authorization and instructions concerning shipment. All authorized returns must be sent to Monster
Effects postage prepaid, insured and properly packaged. All warranty service returns must include
positive proof of purchase from the original sale.
During the warranty period Monster Effects shall, at is sole and absolute option, either repair or replace
free of charge any product that proves to be defective upon inspection by Monster Effects or an
authorized repair representative.
This warranty does not cover claims for damage due to abuse, neglect, alteration or attempted repair by
unauthorized personnel and is limited to failures arising during normal use that are due to defects in
material or workmanship in the product.
MONSTER EFFECTS
ATLANTA, GA USA
http://www.monstereffects.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising