Power Supply Removal and Installation

COPYRIGHT © 2005 MERIT INDUSTRIES, INC.
ATTENTION:
OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DEVICES
Removal/Installation of Major Assemblies eVo/eVo Wallette/Elite Edge Ion
Power Supply Removal
1. Turn off and unplug the game.
2. Unlock and open the CPU section.
3. Unplug the IEC connector from the power supply. See Figure 1.
4. Disconnect the wire connector nearest to the power supply.
5. Remove the 2 screws fastening the power supply and mounting bracket to the game. See
Figure 2.
6. Remove the power supply.
Power Supply Installation
1. Install the new power supply and bracket in the game and fasten them with the 2 screws that
were used to fasten the old power supply and bracket. See Figure 2.
2. Connect the power supply wire connection.
3. Reconnect the IEC connector to the power supply. See Figure 1.
4. Close and lock the CPU section.
5. Plug in and turn on the game.
IEC CONNECTOR
POWER
SUPPLY
HARD
DRIVE
FIGURE 1 - OVERVIEW OF HARD DRIVE
FIGURE 2 - POWER SUPPLY MOUNTING
SCREWS (2 PLACES)
Troubleshooting Information - Removal/Installation of Major Assemblies eVo/eVo Wallette/Elite Edge Ion
Megatouch Ion Technical Reference Manual