Smart-UPS™ Installation Guide
750/1000/1500/2200/3000 VA 120/230 Vac
500 VA 100 Vac Tower
Important Safety Messages
Read the instructions carefully to become familiar with the equipment before trying to install, operate, service
or maintain it. The following special messages may appear throughout this manual or on the equipment to
warn of potential hazards or to call attention to information that clarifies or simplifies a procedure.
The addition of this symbol to a Caution product safety label indicates that an electrical hazard
exists which will result in personal injury if the instructions are not followed.
The following safety messages may appear throughout this manual to warn of potential hazards.
CAUTION
CAUTION indicates a potentially hazardous situation which, if not avoided, can result in equipment damage and minor or
moderate injury.
CAUTION
CAUTION indicates a potentially hazardous situation which, if not avoided, can result in equipment damage.
Safety and General Information
Inspect the package contents upon receipt. Notify the carrier and dealer if there is any damage.
Read the Safety Guide supplied with this unit before installing the UPS.
• Adhere to all national and local electrical codes.
• This UPS is intended for indoor use only.
• Do not operate this UPS in direct sunlight, in contact with fluids, or where there is excessive dust or
humidity.
• Be sure the air vents on the UPS are not blocked. Allow adequate space for proper ventilation.
• The battery typically lasts for two to five years. Environmental factors impact battery life. Elevated
ambient temperatures, poor quality utility power, and frequent short duration discharges will shorten
battery life.
• Connect the UPS power cable directly to a wall outlet. Do not use surge protectors or extension cords.
• The equipment is heavy. Always practice safe lifting techniques adequate for the weight of the
equipment.
• The model and serial numbers are located on a small, rear panel label. For some models, an additional
label is located on the chassis under the front bezel.
• Always recycle used batteries.
• Recycle the package materials or save them for reuse.
Inventory
All models
120/230 Vac models
(1) Documentation CD
(1)
120/230 Vac models
(1) PowerChute software CD
(1)
(1)
230 Vac models
(2)
2200/3000 VA models
(1)
2200/3000 VA models
(1)
2200/3000 VA models
(1)
Rear panel features 500 VA to 1500 VA models
1000/1500 VA 100 Vac
1000/1500 VA 120 Vac
1000/1500 VA 230 Vac
G RO UP 1
G R O UP 1
su0327b
750 VA 230 Vac
su0326b
500 VA 100 Vac
750 VA 100/120 Vac
su0325c
1
2
3
4
5
6
7
8
2
USB port
RJ45 connector - serial UPS monitoring port
Chassis ground screw
SmartSlot for optional NMC accessory card
Circuit breaker/Overload protection
UPS input
Outlets
Internal or external battery connector
Smart-UPS 750/1000/1500/2200/3000 VA 120/230 Vac 500 VA 100 Vac Tower
su0328c
Rear panel features 2200 VA / 3000 VA models
2200/3000 VA 100 Vac
3000 VA 120 Vac
2200 VA 120 Vac
2200/3000 VA 230 Vac
GR O U P 1
GR O U P 1
su0351a
su0330b
su0329a
GROUP 1
1 USB port
2 RJ45 connector - serial UPS monitoring port
3 Chassis ground screw
4 SmartSlot for optional NMC accessory card
5 Circuit breaker/Overload protection
6 UPS input
7 Outlets
8 EPO connector
Installation
2200/3000 VA models
Remove the bezel
su0352b
su0355a
500/750/1000/1500 VA models
Connect the battery
su0354a
Insert the battery connector into the battery jack and push firmly. A snap will be felt as the
connector partially engaes the jack. A second snap will be felt as the connector securely seats in
the battery jack.
Smart-UPS 750/1000/1500/2200/3000 VA 120/230 Vac 500 VA 100 Vac Tower
3
Electrical connections
CAUTION
RISK OF EQUIPMENT DAMAGE
• Adhere to all national and local electrical codes.
• Wiring should be performed by qualified electrician.
• Always connect the UPS to a grounded outlet.
Failure to follow these instructions can result in equipment damage
s u0 44 1a
Plug type and connector locations may vary.
Display panel features
1
2
3
4
5
6
7
8
9
Online LED
UPS ON/OFF key
On Battery LED
Fault LED
Replace Battery LED
Display interface
UP/DOWN arrow keys
ENTER key
ESC key
APC by Schneider
Electric
su0343a
Controlled outlet groups
Some UPS models have one bank of outlets that can function as a controlled group. Use the display interface to
configure the controlled outlet features, navigate to:
Main Menu > Control > Outlet1 Control.
Refer to Rear panel features on pages 2 and 3 for model specific outlet groups.
Select models are ENERGY STAR® qualified.
For more information go to www.apc.com/site/recycle/index.cfm/energy-efficiency/energy-star/
© 2013 APC by Schneider Electric. APC, the APC logo, and Smart-UPS are owned by Schneider
Electric Industries S.A.S., or their affiliated companies. All other trademarks are property of their
respective owners.
EN 990-3535D-002
05/2013