Canon | Optura 100 MC | Canon Optura 100MC Speaker Replacement

Canon Optura 100MC Speaker Replacement
Canon Optura 100MC Speaker Replacement
This guide instructs about how to remove and replace the speaker in the Canon Optura
100MC.
Written By: Jeanette Neethling
INTRODUCTION
Use this guide to replace or repair your speaker.
TOOLS:
Phillips #00 Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 13
Canon Optura 100MC Speaker Replacement
Step 1 — The side of the Device

Orient the camera so that the
viewfinder is on your left and the
lens is on your right.

Remove the 4mm #00 Phillips
screw.
Step 2

Reorient the camera with the back
button pad and viewfinder towards
you.

Remove the three 4mm #00 Phillips
screws shown on the rear face of
camcorder.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 13
Canon Optura 100MC Speaker Replacement
Step 3

Remove the plastic cover from the rear of the camcorder by gently pulling it towards you
while holding the camera as shown.
 The Battery Should be removed at this point, please ignore it in the picture.
Step 4

Remove the 4mm #00 Phillips
screw located to the right of the
LCD release switch.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 13
Canon Optura 100MC Speaker Replacement
Step 5

Open the LCD by using the release
switch.

Reorient the camera with the
playback button pad and edge of
LCD screen facing you.

Remove the 4mm #00 Phillips
screw shown.
Step 6

Reorient the camera with the top
facing you. The side with the LCD
screen should be on the right and
the other side panel should be on
the right.

Open the pop up flash on the top of
the camcorder.
 A loud clicking noise is expected.

Remove the 4mm #00 Phillips
screw shown.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 13
Canon Optura 100MC Speaker Replacement
Step 7

Reorient the camera with the bottom facing you, LCD screen on the right, side panel on the
left.

Open the tape deck by sliding the switch and moving the deck cover to the left as shown.
Step 8

© iFixit — CC BY-NC-SA
www.iFixit.com
Remove 4mm #00 Phillips screw.
Page 5 of 13
Canon Optura 100MC Speaker Replacement
Step 9

Reorient camera with lens facing
you.

Remove the #00 Philips 4mm
screw shown on the hinge of the
tape deck cover.
Step 10

To remove the camcorder lens hood, twist the hood to counterclockwise and it will come
loose, then pull towards you.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 6 of 13
Canon Optura 100MC Speaker Replacement
Step 11

Close the tape deck by gently pushing it toward the body of the camera.

Slide and remove the plastic cover on the bottom right, exposing the interface shown.
Step 12

Gently pull the front plastic cover towards you to remove.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 7 of 13
Canon Optura 100MC Speaker Replacement
Step 13

Remove 2 Philips #00 4mm screw
shown.
Step 14

Reorient the camera so you are
looking at the side of the camera
with the viewfinder on the left and
lens on the right.

Holding the camera as
shown,remove the 4mm #00
Phillips screw.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 8 of 13
Canon Optura 100MC Speaker Replacement
Step 15

Remove the 4 Philips #00 4mm
screws shown.
Step 16

Reorient the camera with the lens
facing you.

Gently pull the side panel of the
camera to the right to remove.
 Be aware that that there are wires
connecting the cover to the body of
the device, so the side cover will
not come off entirely.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 9 of 13
Canon Optura 100MC Speaker Replacement
Step 17
 The side of the device should now
be open as shown. Again, there are
wire connections between the side
cover and the body of the
camcorder. Do not separate the
two entirely!
Step 18 — Speaker

Remove the screw above the
speaker's housing.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 10 of 13
Canon Optura 100MC Speaker Replacement
Step 19

Remove the small battery with the
"Caution" on it.
Step 20

Remove the screw from inside the
battery housing.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 11 of 13
Canon Optura 100MC Speaker Replacement
Step 21

Remove the 3 screws holding the
metal piece over the speaker.
Step 22

© iFixit — CC BY-NC-SA
www.iFixit.com
Lift up and remove the metal cover.
Page 12 of 13
Canon Optura 100MC Speaker Replacement
Step 23

Lift and remove the speaker.

Replace the broken speaker with a
Step 24
new one.
 The speaker's wires need to be
desoldered.
To reassemble your device, follow these instructions in reverse order.
This document was last generated on 2015-05-05 10:33:18 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 13 of 13
Download PDF