NPS 910/901-MY/WT Combo Non-Sound Lectern Owner's Manual

Add to my manuals
4 Pages

advertisement

NPS 910/901-MY/WT Combo Non-Sound Lectern Owner's Manual | Manualzz
Veneer Contemporary Lectern
900 Series
Product Handbook
Model #910/901
Model #950/901
Oklahoma Sound
SERIES 900 VENEER CONTEMPORARY LECTERN
MODEL #950 / 901 TABLE LECTERN WITH SOUND
Lecterns are constructed of plywood and hardwood for
strength and rigidity. Makes a strong design statement
while blending with almost any decor. Presents a
stately and sophisticated appearance that works well
in corporate or executive offices. Appealing curvilinear
design makes it suitable for conference rooms, and
training rooms.
Rich Veneer Amplified Sound Lectern on Plywood
Core in Contemporary. Transitional style commands a
dignified presence. Modern stylistic radius curves and
contoured edging. Custom built in 75 watt Multimedia
Amplifier Sound System broadcasts for audiences up
to 7500 people or 75,000 sq. ft. Four 4-inch speakers
mounted directly on radius corners with radius style
grille, contribute to the Luxurious appearance and afford
high quality audio amplification. Multimedia capabilities
include capacity for two microphones and one wireless
user. Inputs for tape and CD and extension speaker and
recording outputs. Reading Lamp illuminates generous
reading surface large enough for 3 ring binder. Digital
timepiece included. Mahogany on Walnut. When placed
on #901 Base, Total Height 49”. One shelf each 9”H x
11”L x 23”W.
CARE OF YOUR CABINET
All exterior and interior exposed surfaces are veneer
covered as well as edges in matching patterned veneer
material. To refresh the appearance, wipe the surface
with a cloth soaked lightly in furniture oil. Avoid speaker
grill area. Your cabinet will look as good as new.
MODEL #910 / 901 NON-SOUND TABLE LECTERN
Specifications (Model #950)
Power Output. . . . . . . . .75 Watt
Rich Veneer Lectern on Plywood Core in Contemporary/
Transitional style commands a dignified presence.
Modern stylistic radius curves and contoured edging.
Reading Lamp illuminates generous reading surface
large enough for 3 ring binder. Digital timepiece included.
Mahogany on Walnut. Reading surface 22”W x 14”L. One
shelf 9”H x 11”L x 23”W. Total Height 22”.
Microphones. . . . . . . . . .2 condenser types:
Handheld with 9” cable
& Tie Clip with 10” cable.
Speakers. . . . . . . . . . . . .Four 4” High Efficiency Speakers.
Input . . . . . . . . . . . . . . . .2 Mics, 1 Aux./Wireless
Output . . . . . . . . . . . . . .Line out 1-Extension
Speaker, Line out 2-Tape Recorder.
Rich Veneer Lectern Base on Plywood core in
Contemporary/Transitional style Rich Veneer Lectern Top
to a full floor Lectern commanding a dignified presence.
Modern stylistic radius curves. Two locking doors
conceal an Adjustable Shelf with five adjustment levels.
Fingertip cutouts for easy door opening. Rolls easily on
four furniture grade casters. Mahogany on Walnut. Two
shelves. Each 11”H x 16”D x 22”L. Total Height 26.5”.
Controls . . . . . . . . . . . . .Four Volume, Bass/Treble,
On/Off Fuse Internally
Mounted, 2A
Power Supply . . . . . . . . .117 Volt AC; 12 V DC
w/Optional Battery
Recharger . . . . . . . . . . . .Internally mounted;
with LED indicator.
Dimensions. . . . . . . . . . .47”H x 22”W x 18”D
2
The 900 Veneer Series
900 SERIES AMPLIFIER OPERATING INSTRUCTIONS
Operating Precautions
Before operating the amplifier, be sure you fully understand all instructions and features of the amplifier. DO NOT turn amplifier on until all input and output connections have been made. NEVER replace fuses unless power is off.
Microphone Input Connection
The microphone input accepts 1/4” phone jack. Do not position microphone next to or facing speakers. This may cause
acoustic feedback.
Auxiliary Input
One auxiliary input is provided for radio tuner, tape recorder, CD player or multi-media equipment. Output level is adjusted
by the auxiliary volume control.
Tone / Equalization Controls
The Low and High frequency controls are similar to the bass and treble controls found on most stereo systems. Optimum
tone is achieved by first setting both knobs halfway; adjust Low and High frequency controls to suit environment.
Auxiliary / Line Out
Connect additional speaker line to navy line out connector of the amplifier. For maximum power transfer and to avoid amplifier overload, be sure that the total impedance of the speaker line matches the output impedance setting on amplifier. Be
sure that speaker terminals are not shorted together by speaker line connecting cables. Can also be used for a recording
device.
Power Supply 12V DC Operation
Connect a 12 volt rechargeable battery 5 Amp (not included) to the battery input connector located on the panel of the
amplifier (using 6’ battery cable). Be sure that the positive pole of battery is connected to the white wire terminal (+) and
the negative pole to the Brass wire (–). When lectern is plugged into a standard wall outlet, the battery will automatically
recharge. Green indicator light illuminates during recharge mode.
Precautions
• Set Mic volume control on lowest when turning unit on.
• Insure correct polarity for D.C. supply connections.
• Reverse connection will blow the fuse and may damage internal circuitry.
• Always replace fuse with specified rating.
Removal and Installation of Amplifier
If your amplifier has to be removed for servicing — follow these simple steps:
1) Disconnect A/C wall plug.
2) Remove 4 side screws two on each side panel under amp top.
3) Disconnect speaker wire at rear of amplifier.
4) Pack it into a strong box with ample cushioning and return to factory.
5) To install new amplifier reverse the above procedure.
3
Oklahoma Sound
optional / additional equipment
Your lectern includes two corded microphones.
For complete freedom of movement, use any of these wireless systems.
hand-held wireless mic / lwm-5
This wireless hand-held mic uses a 9-volt battery. Select channel A or B
to eliminate outside frequency interruption. Move freely up to 200 ft. away!
Tie-clip lavelier wireless mic / lwm-6
Includes pocket-size transmitter with a clip-on mic. Uses a 9-volt battery. Select channel A or B
to eliminate outside frequency interruption. Move freely up to 200 ft. away!
headset wireless mic / lwm-7
Includes pocket-size transmitter with a headset mic. Uses a 9-volt battery. Select channel A or B
to eliminate outside frequency interruption. Move freely up to 200 ft. away!
For these products, please contact your dealer or Oklahoma Sound.
Manufacturers Warranty
Our Lecterns undergo the most rigid and exacting tests for superior quality and performance before leaving the factory.
Oklahoma Sound Corporation warrants this product to be free from defective material and workmanship on the
electronic product speakers and microphones for five years from the date of resale by an authorized Oklahoma Sound
distributor. Oklahoma Sound will replace defective parts and repair malfunctioning products under this warranty
when the defect occurs under normal installation and use, provided the unit is returned to our factory via prepaid
transportation after direct authorization and approval by Oklahoma Sound. This warranty provides that examination
of the returned product must disclose in our judgement, a manufacturing defect. This warranty does not extend to
any product which has been subject to misuse, neglect, accident, improper installation, or where the serial number
has been removed or defected and is given in lieu of any other warranty implied or expressed and will not cover any
consequential damages.
Oklahoma Sound
149 Entin Road, Clifton, NJ 07014
Tel 973-594-9000 • Fax 973-594-9339
www.oklahomasound.com • email: [email protected]

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement