IP Link® Device Interface
Ethernet Communication Sheet
barc_1_7350_1.pkn
Revision: 6/3/2014
This document provides additional assistance with wiring your Extron IP Link enabled product to your device.
Different components may require a different wiring scheme than those listed below.
For complete operating instructions, refer to the user’s manual for the specific Extron IP Link enabled product or
the controlled device manufacturer supplied documentation.
Device Specifications:
Device Type:
Manufacturer:
Firmware Version:
Model(s):
Video Projector
Barco
N/A
HDX-W12, HDX-W14, HDX-W18, HDX-W20
Minimum Software and Firmware Requirements:
IP Link
Compiler
IP Link
Firmware
1.6.0
1.17
GC Version
3.5.2
Version History:
Driver
Version
Date
1
5/30/2014
Notes
Initial version.
Driver Notes:
 After projector is powered on, lamp will turn on 30 seconds later.
Page 1 of 3
IP Link® Device Interface
Ethernet Communication Sheet
barc_1_7350_1.pkn
Revision: 6/3/2014
Control Commands & States:
Aspect Ratio
4:3
16:9
5:4
2.35:1
1.88
1.85:1
1.78:1
16:10
1.67
Custom
Freeze
On
Off
Input
Input 1
Input 2
Input 3
Input 4
Power Control
On
Off
4:3
16:9
5:4
2.35:1
1.88
1.85:1
1.78:1
16:10
1.67
Status Available:
Aspect Ratio
Custom
Connection Status
Connected
Disconnected
Freeze
On
Off
Input
Input 1
Input 2
Input 3
Input 4
Lamp Usage
Hours
Operation Hours
Hours
Power Control
On
Off
Power Status
On
Off
Page 2 of 3
Status Unavailable
IP Link® Device Interface
Ethernet Communication Sheet
barc_1_7350_1.pkn
Revision: 6/3/2014
Network communication:
When configuring the Ethernet driver, be sure device settings match that of the GC configuration.
Port Type:
Ethernet
Logon Credentials
Supported:
Default Port:
Undetermined
Multi-Connection
Capable:
Port Changeable:
Yes
43680
Yes
Ethernet Driver Configuration Description:
Please refer to user manual for settings and changes to the network communication parameters such as Port Number.
Notes for the Device:
Page 3 of 3