Package content
Install the TF card
Power
(02)
1. Inserting the TF card(As shown in figure1)
(03)
Insert the TF card into the slot according to the shell logo direction, push to hear "beep"
sound and release. Then the TF Card is installed.
1. Power on
When powered off, long press “POWER” to turn on
the device.
When powered on, short press “POWER” to
activate or turn off the screen. When the screen is
turned off, you can only operate the “POWER”,
”Volume+”, and ”Volume-” button.
Key functions
(01)
The package includes following accessories (The quantity for each accessory is
one ). Please carefully verify when purchasing. If anything absent, please contact
with the device supplier timely.
取出TF卡
(04)
(12)
Figure 1
Figure 2
装入TF卡
(05)
Advice: when you play music long time, please turn off the
screen to improve this player's endurance performance.
(06)
(07)
(13)
(08)
Player
Sport arm belt
(14)
(09)
3.5mm headphone
2. Power off
1) The player is turned on and the screen is
lighted, long press “POWER”. And it will turn off.
2) The player is turned on and the screen is out,
firstly press “POWER” to activate the screen. Then
long press “POWER”, you can turn off the device.
(15)
(10)
(11)
(16)
2. Pull out the TF card(As shown in figure 2)
Hi-Fi Music Player
Hi-Fi Music Player
Gently push the TF card bottom to hear "Di" sound, then slowly let go. You can see TF
Card pops up about 3mm. then you can directly take the card.
快速操作手册
保修说明
产品合格证
(01)
Line output /SPDIF Optical fiber output
(09)
Jogdial
(02)
Headphone output
(10)
Play/ OK
(03)
USB cable (power cable)
Quick guide
Warranty card
Notes:lotoo official website supply electronic version of the User manual book and fast setup.
Please visit www.lotoo.cn and download.
Balance type headphone output(2.5mm) (11)
Gain(high/low)
(04)
damp(high/low)
(12)
(05)
Volume up
(13)
(06)
Volume down
(14)
Return/Setup(Long press)
(07)
Next/Fast forward
(15)
ATE/PMEQ music effects
(08)
Previous/Fast reverse
(16)
Power/lock Screen
Liquid crystal display
Music/Fn(long press)
Instruction:
1) The device will turn on normally when the TF card is inserted. The device if self hasn't memory
capacity.
2) Theoretically, the device can support TF card with 2T capacity maximum.
3) The device can support the TF card with FAT32 format. So we advise: When inserting the TF card,
please format it first before use.
4) When inserting or pulling out the TF card, please be gentle, otherwise it may cause damage to
the TF card.
5) You can place four TF cards into the moving arm belt's bracket . Please follow the direction of
identification.
3. Recharge
This device will recharge automatically when connect to 220V power supply with
the power adapter. When the player is off, long press <power > to turn on the
device.
· Playing while charging:The externally connected power adapter can supply
power to the device while charging the Lithium battery. Therefore, you can choose to
play music when charging the Lithium battery, which has no influence on the
charging performance.
Notes: you need buy the power adapter separately.
FCC Statement:
reception, which can be determined by turning the
This equipment has been tested and found to comply
equipment off and on, the user is encouraged to try
with the limits for a Class B digital device, pursuant
to correct the interference by one or more of the
to part 15 of the FCC rules. These limits are
following measures:
designed to provide reasonable protection against
-Reorient or relocate the receiving antenna.
harmful interference in a residential installation.
-Increase the separation between the equipment and
This equipment generates, uses and can radiate radio
receiver.
frequency energy and, if not installed and used in
-Connect the equipment into an outlet on a circuit
accordance with the instructions, may cause harmful
different from that to which the receiver is
interference to radio communications. However,
connected.
there is no guarantee that interference will not occur
-Consult the dealer or an experienced radio/TV
in a particular installation. If this equipment does
technician for help.
cause harmful interference to radio or television
To assure continued compliance, any changes or
modifications not expressly approved by the party
Caution!
Responsible for compliance could void the user’s
The manufacturer is not responsible for any radio or
authority to operate this equipment.
TV interference caused by unauthorized
(Example- use only shielded interface cables when
modifications to this equipment. Such modifications
connecting to computer or peripheral devices).
could void the user authority to operate the
This equipment complies with Part 15 of the FCC
equipment.
Rules. Operation is subject to the following two
conditions:
MODIFICATION: Any changes or modifications
(1) This device may not cause harmful interference,
not expressly approved by the grantee of this device
and
could void the user’s authority to operate the device.
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
">