BONTEC ST-13 Universal Table Top Pedestal TV Stand Instruction manual

INSTALLATION MANUAL
      
Model: ST-13
 
Carefully open the carton, remove contents and lay out on cardboard or other
protective surface to avoid damage.
Check package contents against the Supplied Parts List in the next page to
assure that all components were received undamaged. Do not use damaged
or defective parts.
Carefully read all instructions before attempting installation.
  
Install and operate this device with care. Please read this instruction before
beginning the installation, and carefully follow all instructions contained herein.
Use proper safety equipment during installation.
Please call a qualified installation contractor for help if you:
If you don't understand these directions or have any doubts about the safety of
the installation.
If you are uncertain about the nature of your wall, consult a qualified installation
contractor.
Do not use this product for any purpose or in any configuration not explicitly
specified in this instruction. We hereby disclaim any and all liability for injury
or damage arising from incorrect assembly, incorrect mounting, or incorrect
use of this product.
Supplied Parts
TV Plate
A (X2)
TV Plate
B (X1)
Support Column
E (X1)
Support Column
F (X1)
Metal Washer
Ø6.5 X Ø12 X 1.2
I (X10)
M6x30 Bolt
J (X3)
Monitor Bracket
C (X2)
Plastic Socket
G (X1)
Metal Pad
K (X1)
1
Tempered Glass
D (X1)
M6x10 Bolt
H (X10)
Rubber Foot
L (X6)
Wire Clip
M (X2)
Buckle
N (X2)
M5x30 Bolt
O (X2)
Allen Key
P (X1)
M4x30 Bolt
W-A (X4)
M6x15 Bolt
W-B (X4)
M6x30 Bolt
W-C (X4)
M8x20 Bolt
W-D (X4)
M8x50 Bolt
W-E (X4)
Square Washer
W-F (X4)
5mm Spacer
W-G (X8)
10mm Spacer
W-H (X8)
Cable Ties
W-I (X2)
 
   
  
D

L
2

E
F
H
I
P
3

F
P
J
E
G
K
 2
D
      

A
B
P
H
4
I

P
H
I
Height
Adjustable
*TV Plate can be installed on wall optionally,
wall mounting hardware have not included.
5

M
6
 
      
First of all, make sure the diameter of the Bolt(W-A to W-E) your TV requires. Once you have
determined the correct diameter,please see the diagram as below. You will thread the Bolt
into the TV using the correct Washer(W-F), and using the spacer(W-G,W-H) if necessary.
Please make sure the Monitor Brackets are vertically centered and level with each other.
C
W-A/W-B/W-C
W-D/W-E
W-F
7
W-G
W-H
 
      
 


Hang the TV onto Stand, there are two gears
that can be adjusted!
8

O
N
9

10