BEA 78.7001.02 LZR-FLATSCAN 3D SW On-Door Instruction manual

LZR-FLATSCAN 3D SW
Mounting Template
RIGHT
1
1
2
2
Also survey both sides of door to determine appropriate mounting location (distance from
pivot edge and distance from top of door), taking into account the frame clearance, finger
guard, door arm, etc.
2
HOW TO USE THIS TEMPLATE
When installing a pair of sensors (i.e. primary and secondary sensors), be aware of
the placement of the second sensor before installing the first. There must be
thru-door alignment of the sensors for the wire passage.
1. When determining the mounting area for your sensor, you must consider the space above the
sensor and the space between the sensor and the door hinge.
1
To determine the maximum mounting height, align the upper corner of the left/right
template with your mounting area. BEA advises mounting as high as possible while
avoiding any obstructions to the sensor.
BEA also advises mounting within 5 inches of the pivot point while avoiding any
obstructions (e.g. finger guards, door arms) that could cause damage to the sensor
during door movement.
1
2. Drill the mounting holes (1/8”):
2
1 standard applications
2 applications requiring a spacer
3. If installaing two sensors, drill the wire passage hole (5/16”) within the shaded
area, and then repeat steps 1 and 2 on the opposite side of the door.
LEFT
1
20230824
1
2
78.7001.02
2
For UL10 compliance, ensure the wire passage hole is offset a
minimum of 1 inch from the hole on the other side of the door.
">