lifepro AC 100240V Leg Massager Circulation Pain Relief User Manual

Lifepro AC 100240V is your new fitness go-to. Use the AllevaWrap post-workout to speed up your workout recovery or pre-workout to enhance your performance. AllevaWrap uses heat, compression, and vibration to provide a deeply penetrating massage for your muscles and fascia, which improves blood circulation and lymphatic drainage, promotes healing, and reduces inflammation.

PDF Download
Document
lifepro AC 100240V Leg Massager Circulation Pain Relief User Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Compression therapy helps strengthen vein support which improves blood flow activity in the legs and feet.
  • Two massage modes, five massage intensity levels, and two heat and vibration levels allow you to choose the perfect settings for all of your massage needs.
  • Use the AllevaWrap while sitting comfortably on the couch watching TV, reading a book, or working at your desk.
  • Redefine wellness and beauty, and experience the transformative power of the Lifepro AllevaWrap

Frequently asked questions

• Lifepro AllevaWrap Air Compression Leg Massager with Vibration • Remote Control • Power Adapter • Extensions for Larger Leg Sizes (4) • Carrying Bag • User Manual • BONUS Gua Sha Facial Massage Tools (2)

Open the Velcro® straps to fully open both wraps. Notice the two wraps are marked “L” (left) and “R” (right) to ensure correct placement. While sitting in a chair, place one air compression wrap on each leg. Your foot should rest flat in the bottom of the wrap. It will secure around your leg like a boot. Use the Velcro® straps to secure the compression wraps securely (but not too tightly) to your feet, then to your calves, then to your knees, and finally to your thighs.

Locate the air hose attached to each leg compression wrap. The connector at the end of each air hose has three prongs. The connectors are also labeled “L” and “R” to ensure proper placement. Insert the three-prong connector labeled “L” into the LEFT three-prong port in the base of the remote control and the “R” connector into the port on the right. The “L” and “R” face OUT.

Connect the power adapter to the base of the remote control.

Press the “Mode” button on the remote control to cycle through the massage modes.

Press the “Strength” button on the remote control to cycle through the intensity levels.

Press the “Vib & Heat” button on the remote control to cycle through the heat and vibration levels.
Preparing document for printing…
0%