Blodgett | XR8-G | Blodgett XR8G startup form 2009-10-08

44 Lakeside Avenue, Burlington Vermont 05401 U.S.A.
Telephone: 1-(800)331-5842 (802)860-3700 D Fax:(802)860-3732
STARTUP PROCEDURE FOR XR8-G ROTATING RACK OVEN
Return form to BLODGETT when job is complete. Submit one form with each unit installed.
SERIAL NO.
MODEL_______________DATE OF INSTALLATION
CUSTOMER
SERVICE AGENCY
ADDRESS
ADDRESS
CITY________________________ STATE_______ ZIP
CITY________________________ STATE_______ ZIP
PHONE:(______)
PHONE:(______)______________ MECHANIC
GAS: V NATURAL
V LP V OTHER
ELECTRIC: V
VOLTAGE_____________ PHASE
The rating plate is located underneath the control panel.
OPERATIONAL START-UP PROCEDURE
Information can be found in the installation manual or by contacting the factory. Write in N/A if not applicable.
1. How many inches clearance on the right side of the oven?
Inches
2. What is located to the right of the oven?
3. Is the oven level? If no, level the unit.
Yes
No
4. How is the oven vented? If under canopy hood, what is the C.F.M rating?
Canopy
CFM
Direct Vent
If hood is not operational or direct vent is not connected, DO NOT startup the oven. If venting is not adequate, DO NOT startup the oven.
5. What is the applied voltage to the oven?
VAC
6. Are all electrical connections tight?
Yes
No
7. What is the size of incoming gas line?
Inch
8. Confirm that all gas connections are tight and leak tested.
Yes
No
9. Is restraining cable connected if oven is on casters?
Yes
No
10. What is the regulated manifold pressure?
____ ”w.c. ____ mbar ____ kPa
11. What is the static supply pressure with all gas appliances off?
____ ”w.c. ____ mbar ____ kPa
12. What is the supply pressure with all gas appliances turned on?
____ ”w.c. ____ mbar ____ kPa
13. Are interior components in place and secure?
Yes
No
14. Is the fan blade unobstructed and turning freely?
Yes
No
15. Does the door latch and gasket seal properly?
Yes
No
16. Set the temperature to 400 F. Does unit maintain temperature?
Yes
No
17. Does the plumbing comply with all applicable codes?
Yes
No
18. Is the water supply pressure between 30 to 75 PSI?
Yes
No
19. Is the water regulator flow pressure set to 10 PSI when solenoid is open?
Yes
No
20. Set the steam time to 20 seconds. Does the water pressure maintain 10 PSI
Yes
No
when the water solenoid is open?
21. Does rotating rack operate smoothly?
Yes
No
22. Does the rotating rack stop squarely when doors are opened?
Yes
No
23. Are the rack gudes installed properly?
Yes
No
24. Is the burner area free and clean of combustibles?
Yes
No
25. Is the draft inducer area free and clean of combustibles?
Yes
No
26. Is the flue exhaust guard positioned upward to prevent items from being
Yes
No
placed over the flue?
NOTES:
This appliance may be equipped with proprietary features and/or components which are for the exclusive use of the customer indicated above.
Further, there may be procedures and/or methods being utilized in preparing this customer’s product which may be proprietary. I hereby certify
that this information will be held in confidence and not disclosed to any third party for whom it is not intended.
Store Manager’s Signature
Service Agent’s Signature
FORM/Serv.25
(White Copy To Blodgett Warranty Department, Yellow Copy To Customer, Pink Copy To Service Agency)
P/N 50414 Rev A
Download PDF