Assembly Instructions
Xsede
™
Jumper to Electrical Block
Installation
1
Figure A
Tools Required
N/A
Hardware Required
1-Electrical Kit
Installation
1.
2.
3.
Unpack electrical kit. (Take care to insure that proper
electrical kit is used as specified by both the floor and
elevation plan views.)
Orient the jumper so the pen housing matches the block,
with the rounded pen pointing the same direction as
shown in Figure A.
Using two hands slide the jumper on to the electrical
block. See figure B.
Figure B
(Note: Make sure jumper is securely snapped to the
electrical block)
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part 2633059, Revision -
">
