30-inch (22-inch deep) low profile pro series wall hood specifications

30-INCH (22-INCH DEEP) LOW PROFILE PRO SERIES WALL HOOD
SPECIFICATIONS
S P E C I F I C AT I O N S
OVERALL DIMENSIONS
Overall Width of Hood
30" (762 mm)
Overall Height of Hood
10" (254 mm)
Overall Depth of Hood
22" (559 mm)
Finish
CFM Recommendation
Classic Stainless Steel
1 cfm per 100 Btu / hr (.03 kWh)
10" (254)
OVERALL
HEIGHT
30" (762)
OVERALL WIDTH
12"
(305)
Internal Blower
600 cfm included
Transition
Included
Duct Size
8" (203 mm) Round
Backdraft
Included
Discharge
Vertical
4" (102)
22" (559)
OVERALL DEPTH
Dimensions may vary by +_ 1/8" (3 mm).
Electrical Supply Requirements
Dimensions in parentheses are in millimeters.
110 / 120 V AC, 60 Hz,
15 amp dedicated circuit
BLOWER OPTIONS
600 cfm Internal Blower
Shipping Weight
39 lbs (17.7 kg) without blower
Do not use with Wolf dual fuel range, gas range and
rangetop models with a charbroiler or griddle.
ACCESSORIES
Decorative rail in stainless steel, platinum,
copper or brass
Specifications are subject to change without notice.
38" (965 mm) H stainless steel backsplash
with warming rack
38" (965 mm) H stainless steel backsplash
6" (152 mm) and 12" (305 mm) duct covers
30-INCH (22-INCH DEEP) LOW PROFILE PRO SERIES WALL HOOD
SPECIFICATIONS
6"
E
(152)
LOCATION OF
ELECTRICAL
FOR TOP
DISCHARGE
5"
(127)
10" (254)
HEIGHT
OF HOOD
30" (762)
WIDTH OF HOOD
30" TO 36"
30" TO 36"
(762 - 914)
TO COOKING
SURFACE
(762 - 914)
TO COOKING
SURFACE
22" (559)
DEPTH OF HOOD
COOKING SURFACE
NOTE:
thethe
Wolf
Design Guide
NOTE:Refer
Refertoto
following
page for
for additional
additionaldetails.
details.
Do not use with Wolf dual fuel range, gas range and rangetop models with a charbroiler or griddle.
Dimensions may vary by +_ 1/8" (3 mm).
Dimensions in parentheses are in millimeters.
DIMENSIONS
Overall Width of Hood
30" (762 mm)
Overall Height of Hood
10" (254 mm)
Overall Depth of Hood
22" (559 mm)
Cooking Surface to Bottom of Hood
30" (762 mm) to 36" (914 mm)
Location of Electrical
See Installation Instructions shipped with unit for detailed specifications.
Within shaded area
30-INCH (22-INCH DEEP) LOW PROFILE PRO SERIES WALL HOOD
SPECIFICATIONS
PRO SERIES WALL
HOODS
PLANNING AND
DESIGN INFORMATION
The Pro Series wall hoods are recommended for use with
all Wolf cooking appliances, with a few exceptions for
the 22" (559 mm) deep hoods. All Pro Series wall hoods
are available in classic stainless steel. (R) models include
mounting holes for the optional decorative rail.
Wolf Pro Series wall hoods are recommended for use
with any Wolf cooking appliance, and should be as least
as wide as the cooking surface. It is recommended that
the hood overlap the cooking surface by 3" (76 mm) on
either side.
22" (559 mm) Deep Wall Hoods
Available in 30" (762 mm), 36"
(914 mm), 42" (1067 mm) and 48" (1219 mm) widths.
(I) models include a 600 cfm internal blower. Do not use
with Wolf dual fuel range, gas range and rangetop models with a charbroiler or griddle.
Installation of all Pro Series wall hoods should be 30"
(762 mm) to 36" (914 mm) from the bottom of the
hood to the cooking surface.
NOTE: Rear discharge is only applicable on 22" (559
mm) wall hoods (excluding W302210I and W362210I)
and 24" (610 mm) wall hoods used with a WBLOWER120INT (804702) or any Wolf remote blower. WBLOWER90INT (805086) is not for use in rear discharge applications.
Also available are the following hoods (see specific PDF
file for additional information):
24" (610 mm) Deep Wall Hoods
Available in 30" (762 mm), 36"
(914 mm), 42" (1067 mm), 48" (1219 mm), 54" (1372
mm), 60" (1524 mm) and 66" (1676 mm) widths.
27" (686 mm) Deep Wall Hoods
Available in 30" (762 mm), 36"
(914 mm), 42" (1067 mm), 48" (1219 mm), 54" (1372
mm), 60" (1524 mm) and 66" (1676 mm) widths.
Models W302210I and W362210I come with internal
blowers, all other wall hoods are shipped without the
blower assembly. The blower or ventilator assemblies are
quite varied, and depending on the amount of air you
want to move and the length of the duct run, you have
many options. You also need to consider if you are going
to use these assemblies as internal blowers or mount
them externally.
Refer to the Pro Series Ventilation Recommendations
charts at the end of this section or contact your Wolf
dealer for additional information.
30-INCH (22-INCH DEEP) LOW PROFILE PRO SERIES
WALL HOOD VENTILATION
REQUIREMENTS / RECOMMENDATIONS
O P T I O N A L D E C O R AT I V E H O O D R A I L S
These decorative rails can be added to any new design wall or island hood and must
be ordered at the same time as the hood. When placing your order, be sure to
include the proper finish code to correspond with the optional bezel package you
may be requesting. They are available only with the "New Design" Pro Series Hoods.
Stainless Steel (SS)
Brass (BR)
Copper (COP)
Platinum (PLT)
D E C O R AT I V E H O O D R A I L S
Number
Description
Hood Type
RAIL-30 / __
Decorative Hood Rail
30-inch Wall Hood
PRO SERIES BACKSPLASHES
Number
Description
Hood Type
30BAK-SPLH/DF
30"W x 38"H Backsplash with 2 Warming Racks
30-inch Wall Hoods
30BAK/DF
30”W X 38”H Stainless Steel Backsplash
30-inch Wall hoods
PRO SERIES DUCT COVERS – WALL HOODS
Number
Description
Hood Type
DUC6COVER30W
6-inch Duct Cover
30-inch Wall Hoods
DUC12COVER30W
12-inch Duct Cover
30-inch Wall Hoods
MINIMUM CFM REQUIREMENTS
Pro Series Hoods
All Hoods
CT15E
CT15G
CT30E
CT30G
CT36E
CT36G
IG15**
IM15
IS15**
IF15**
215*
215*
600
600
600
600
400*
215*
215*
215*
* Use these requirements to determine total CFM when installing multiple cooking products.
** Downdrafts are not recommended for use with IF15 or IS15.
NOTE: CFM requirements are averages based on total BTU output. Wolf recommends 1 CFM per 100 BTU. Additional CFM
required for charbroilers, griddles and long duct runs.
30-INCH (22-INCH DEEP) LOW PROFILE PRO SERIES
WALL HOOD VENTILATION
REQUIREMENTS / RECOMMENDATIONS
MINIMUM CFM REQUIREMENTS
Wall Hoods (22"D)
R/DF304 R/RT/DF364
R/RT/DF366 R/RT488 R/RT/DF486 R/RT/DF484 R/RT/DF482 R/DF606 R/DF604
W302210I*
600
W362210I*
600
900
900
W362210*
600
900
900
900
900
W422210*
W482210*
900
900
*Do not use with Wolf dual fuel range, gas range and rangetop models with a charbroiler or griddle.
NOTE: CFM requirements are averages based on total BTU output. Wolf recommends 1 CFM per 100 BTU. Additional CFM
required for charbroilers, griddles and long duct runs.
BLOWER CROSS-REFERENCE
Wall Hoods – 22"D x 10"H
Blower
Number
Duct
Discharge
W302210I or W362210I
Internal 600 CFM
Included
8" Round
Vertical
W362210, W422210 or W482210
Remote 600 CFM
CTBLOWER-60REM
8" Round
Adjustable
W362210, W422210 or W482210
Remote 900 CFM
CTBLOWER-90REM
8" Round
Adjustable
NOTE: Do not use with Wolf dual fuel range, gas range and rangetop models with a charbroiler or griddle.
Transition with backdraft damper included.