PROLED L711Lxxx Mini Proled Low Bay Industrial Ceiling Light Installation Guide

Montageanleitung / Installation manual
PROLED LOW BAY MINI 53 / 80
L711Lxxx
Characteristics:
•
•
•
•
•
•
•
•
•
PHILIPS LED Warm White, Neutral White or White
Power consumption 53 W (MINI 53) or 75 (MINI 80)
Aluminium housing anodized
Beam angle 60°
Driver 220 – 240 VAC, 50/60 Hz
Dimmable with 1 – 10 V
Operating temperature range -40° C till +55° C
CE compliant with applicable European directives
Protection class IP20
Warning:
1.
2.
3.
4.
5.
Make sure enough load capacity (min. 10 kg) for fixing point is existing.
Please ensure that the packaging is disposed of in a safe environment.
If cable is defected, do not use the luminaire.
We do recommend that a qualified electrician should be used to install the products.
Do not look at the lighted lamp directly.
Safety indices:
Be sure to have a qualified electrician complete installation. The customer is not entitled to claim for any
lights installed without observing European safety directives. The manufacturer is then discharged from
liability when damage is caused by improper use or installation. If any luminaire is subsequently modified, the
person responsible for the modification shall be considered as manufacturer. Do not cover lamps with heatinsulating materials. During usage the surface becomes hot. Please do not touch the surface until the
luminaire cools down adequately. Protection class IP20.
Installation:
Please follow the sequence of installation step by step. Non-observance can lead to damage of Luminaire.
1. Switch off the electricity at the mains before commencing installation or lamp change and (if a fuse box is
installed) remove the appropriate circuit fuse to avoid accidental switching on of the mains supply.
2. Remove the luminaire and the reflector out of the box.
3. Mount the added loop to the luminaire.
4. Mount the reflector to the luminiare
5. Install the luminaire to the hook. Take care that the hook has enough load (min. 10kg).
6. Connect primary side of driver to power supply (230V). The luminaire must be earthed.
7. The luminaire is in standard dimmable with 1-10 V. If you don’t request dimming, please secure the ends
of dimming cable.
8. Make sure all connections are tight with no loose strands.
9. Ensure fire regulations are not breached when fitting your lights.
10. If you are in any doubt regarding these instructions, consult a qualified electrician.
IP20
MBN GmbH ● Balthasar-Schaller-Str. 3 ● 86316 Friedberg ● Germany
www.proled.com
Montageanleitung / Installation manual
Reflektor only as sample picture.
With delivery as rounded Polycarbonate
1 = Fixing screws for reflector
2 = Reflector PC
3 = Securing washer
4 = Loop
ATTANTION:
During connecting of mains power to primary side of power supply please take care about following:
Red cable = L – wire
Blue cable = N – wire
Green or Yellow cable = Earth
Energy efficiency class of the light source:
Products listed in this manual contain a light source of efficiency class E.
ATTENTION:
Installation and commissioning may only be performed by qualified persons.
National installation regulations must be observed.
Luminiares must be disconnected from mains before any work.
12.21 Technical amendments reserved
MBN GmbH ● Balthasar-Schaller-Str. 3 ● 86316 Friedberg ● Germany
www.proled.com
">