ITEM NUMBER
AVA COLLECTION
YY-CU-TM
‘CU’ STYLE HANDLE TRIM FOR 4-POR T, 5-PORT AND STOP V ALVES
PAGE 01
INSTALLATION INSTRUCTIONS
TEST FOR PROPER FUNCTION BEFORE CLOSING WALLS!
FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION
.
AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.
MINIMUM HOLE SIZE FOR THE HANDLE TRIMS IS 1 5/8” AND MAXIMUM OF 1 3/4”
EXTENSION
ALL THREAD
INSTALLATION INSTRUCTION
STEM
INSTALLING THE VALVE WITH THE TRIM
FINISHED WALL
1- Install the valve onto the wall with at least 2-1/2” space
between the center of the valve inlet and the finished wall.
2-1/2" - 3-1/2"
c enter of IN port
2- Screw the extension all thread and stem onto
the valve making sure it is all the way in.
3- Mark the extension all thread flushed to the wall,
remove it and cut.
Do the same with the stem but this time cut 1/4"
less than the extension thread in order to attach
handle.
CUT EXTENSION
ALL THREAD AND
STEM FLUSH TO WALL
CUT STEM 1/4"
SHORTER FOR HANDLE
INSTALLATION
CUT FLUSH TO
WALL
4- Cut off the excess All Thread and Stem
(remember to cut the Stem 1/4" shorter)
1/4" SHORTER
THAN ALL THREAD
PAGE 02
INSTALLATION INSTRUCTIONS
5 - Replace the handle onto the stem.
Tighten the handle set screw firmly.
6 - Apply the finish trim.
">
