User Manual
Milk Frother
Model No.: MF03
PLEASE READ AND SAVE THESE.
INSTRUCTIONS FOR FUTURE REFERENCE.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed including the following:
1. Read this user manual thoroughly before first use and save it for future reference. Pay attention to the
warnings on the product and in the user manual. It contains important information for your safety as well
as proper use and maintenance of the product.
2. Use the product only for its intended purpose. Use only with recommended accessories and components
supplied with the product. Improper use or wrong operation may lead to hazards.
3. Never leave the product unsupervised or unattended while it is switched ON.
4. Do not place heavy objects on top of the product.
5. WARNING! To protect against fire, electric shock and injury to persons. Do not immerse the milk frother
or the power base in water or any other liquids. Never place the milk frother under running water to
clean. Do not place the product in the dishwasher.
6. If the supply cord is damaged, it must be replaced by qualified electrical person in order to avoid a hazard
or the product must be disposed.
7. The mains voltage must match the information on the rating label of the product.
8. Avoid damages to the power cord. Do not allow the power cord to kink or come in contact with sharp
comers.
9. Keep this product including power cord and plug away from all heat sources, i.e. ovens, hot plates and
other heat-producing devices/objects.
10. Only unplug from the power socket do not pull on the cord.
11. Disconnect the product from mains power
-when the product is not being used;
-in case of malfunctions;
-before attaching/detaching accessories;
-before cleaning and storing the product.
12. Use the product only in dry locations indoors, never use it outside.
13. Place the product on a stable, level, and slip resistant surface.
14. Protect the product from extreme heat and cold, direct sunlight and dust.
15. In order to reduce the risk of fire and electric shock, do not expose the product to fire (fireplace, grill,
candles, cigarettes etc.) or water (water drops, water splashes, vases, tubes, ponds, etc.).
16. CAUTION: Risk of burns! Avoid contact with hot surfaces and escaping steam. Hold the product only
by the handle.
17. Keep a sufficient safety clearance around the product. Hot milk can cause severe scalding.
18. Do not move or transport the product during use or while there is hot milk in the thermos can. Spraying
hot milk poses a risk of burning.
19. Operate the product only when it is filled with milk.
20. Close the lid when frothing or heating.
21. The use of accessory attachments not recommended by the appliance manufacturer may result in fire,
electric shock or injury to persons. This product is not suitable for commercial use. It is designed for
household use only.
22. Do not touch hot surfaces. Use handles or knobs.
23. Close supervision is necessary when any appliance is used by or near children.
24. Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off
parts, and before cleaning the appliance.
25. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has
been damaged in any manner. Return appliance to the nearest authorized service facility for examination,
repair or adjustment.
26. Do not use outdoors.
27. Do not let cord hang over edge of table or counter, or touch hot surfaces.
28. Do not place on or near a hot gas or electric burner, or in a heated oven.
29. To disconnect, turn any control to ″off″, then remove plug from wall outlet.
30. Scalding may occur if the lid is removed during the brewing cycles.
31. To reduce the risk of injury, do not drape cord over the counter top or table top where it can be pulled on
by children or tripped over unintentionally.
32. a) A short power-supply cord is provided to reduce risks resulting from becoming entangled in or
tripping over a longer cord.
b) Longer detachable power-supply cords or extension cords are available and may be used if care is
exercised in their use.
c) If a long detachable power-supply cord or extension cord is used:
1) The marked electrical rating of the detachable power-supply cord or extension cord should be at least
as great as the electrical rating of the appliance.
2) The longer cord should be arranged so that it will not drape over the counter top or table top where it
can be pulled on by children or tripped over.
33. This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric
shock, this plug is intended to fit into a polarized outlet only one way. If the plug does not fit fully into
the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify
the plug in any way.
ADDITIONAL IMPORTANT SAFEGUARDS
1. This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instructions concerning use of the appliance by a person responsible for their safety.
2. Children should be supervised to ensure that they do not play with the appliance.
3. Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised.
4. Keep the product and its cord out of reach of children aged less than 8 years.
5. Caution! To avoid hazards caused by inadvertent resetting of the safety temperature limitei; the product
must not be connected to an external switching device such as a timer switch or connected to an electrical
circuit that is regularly switched ON and OFF.
6. This appliance is intended to be used indoors in household and similar applications such as: staff kitchen
areas in shops, offices and other working environments, farm houses, by clients in hotels, motels and
other residential type environments, bed and breakfast type environments.
7. DO NOT fill with milk over the maximum level capacity.
8. DO NOT use the milk frother to heat oil, or to melt butter.
9. DO NOT place any container inside the milk frother -milk must be removed from the packaging,
container, can, etc. before being put into the carafe.
10. Do not use the appliance to warm milk for a baby.
11. Warning! Never open the lid during the frothing or heating process.
12. Warning! Avoid liquid spillage on the electrical connectors.
13. Warning! Handle with care. The heating element surface is subject to residue heat after use.
14. Use the product only with the base provided.
15. The product must not be immersed in water for cleaning.
16. Switch OFF the appliance and disconnect from mains supply before changing accessories or
approaching parts that move in use.
17. Be careful when hot liquid is poured from the milk frother, as it can be ejected out of the appliance due to
a sudden steaming.
18. Clean the product and any accessories thoroughly after each use. Refer to CLEANING AND CARE
section.
PRODUCT INSTRUCTION………………
………………...…
Transparent Lid
Level Marks
For
Different
Whisk
withoutFunctions:
Spring
Milk heating Max. Level
Whisk with Spring:
Milk frothing Max. Level
Milk frothing Min. Level
Stainless Steel Jug
Non Stick Coating tank
….
!
Handle
Button for Heating Only
or Heating & Frothing
Button for Cold Frothing
Power Base With Cord
!
Whisk
For Frothing Milk
Whisk
For Heating Milk
OPERATING INSTRUSTIONS………
… ………………
……
1. Before The First Use
· Unpack the box with care, remove all the packing materials away from the appliance and keep it for later use;
· Keep the packing material(bag and etc.) away from children for safety;
· Before using the appliance for the first time, please clean the jug and the accessories as described under the
chapter “Cleaning and maintenance” to remove the dust or production residues;
2. Operating Steps
!
Whisk
UHT whole milk is the best choice!
Do not exceed the level marks to avoid over flow.
Function
Minimum Volume
Maximum Volume
Frothing cold milk
60ml
120ml
Frothing & heating
60ml
120ml
Heating
(with some small foam)
60ml
250ml
· Choose the proper whisk and set it inside the jug;
· Pour desired milk into the jug but no more than the maximum volume (Refer to the above table ) to avoid
overflow;
· Push the relevant button to start the appliance and it stops automatically when ready; then enjoy at once with
the fresh frothed/heated milk!
3. Indicator Instruction
· Standby mode: After plugged into the power, buttons will blink once and then extinguish.
· Frothing hot milk: Press the hot milk button (higher one) then the light turns into steady red, the machine
starts heating and frothing till it stops automatically, then pour the frothed milk into your cup as quick as possible
for a quick and perfect hot drink.
· Heating milk: Install the respected whisk(the one without spring), pour desired milk into the jug but no more
than 250ml, and do the same as above to get hot milk without frothing.
· Frothing cold milk: Press the cold milk button then the light turns into steady blue, which means the milk is
well frothed. The machine will stop automatically when finishing.
· Press the corresponding button again to stop the function during frothing or heating when necessary.
4. Hints and tips:
Here are some handy hints to help you get the best from your frother.
· Always use your frother first to froth or heating your milk. While it is operating, prepare your coffee or hot
chocolate and serve immediately.
· Use whole milk (fat content ≥3.0%) for best result.
· Milk heats to approximately 65-75℃, which is the ideal temperature to ensure the flavor of your coffee is not
impaired and so you don’t have to wait too long until you can start enjoying your drink.
· Keep your whisks in a safe place to prevent from missing.
· After frothing or heating, rest the thermostat for 2 minutes before using. Also you can rinse under water to
short the time.
· How to achieve the perfect frothed milk:
- Non-fat or skimmed milk provides the largest foam bubbles and is the easiest for the beginners. Since there
is no fat in the milk, the result is light and airy but flavor is not as rich as other types of milk.
- 2% milk will also foam effortlessly as well as add a more creamy taste than non-fact milk.
- Whole milk is more challenging to achieve the most decadent, rich tasting Cappuccino.
TIPS FOR EASY DRINKS…………………
………
With frothed milk
……
With hot milk
1/3 Espresso
1/3 Espresso shot
2/3 frothed milk
2/3 heated milk and stir
Some coco powder
Cappuccino
Latte Macchiato
Caffe Latte
Pour desired frothed milk
into a tall glass
Pore heated milk
into a big cup
Add espresso carefully
along the rim of the glass
Add chocolate powder and stir
Hot chocolate
Make instant coffee
Place instant coffee
granules in a cup
Add frothed milk
inside
Add hot milk into the cup
and stir
Instant coffee drinks
Instant milky coffee
SPECIFICATION
Rated Voltage: AC120V
Rated Frequency: 60Hz
Rated Power: 550W
N.W./G.W.: 840g/950g
Max. Frothing Capacity: 120ml
Protection Class: I
Product Size: 172×110×183mm (L×W×H)
TROUBLES SHOOTING
Problems
Indicator light doesn’t
work or jug doesn’t work
Jug ceases to work
after starting operation
Motor doesn’t work
No heating
Charring
Causes
Solutions
Plug is not inserted properly
Re-insert into the power
Jug and power base doesn’t
Remove the jug and place again on the
connected properly
base
No power in the socket
Check the electric circuit
Problems with electric elements
Repair
Jug temperature is too high
Rinse cold water inside the jug to reduce
the temperature
Jug damaged with immersion in water
repair
Jug is not cleaned in time after use,
Clean and move the shaft sleeve of motor
milk locks the mechanism
by hand to loosen it
Motor damage
repair
Machine damage
repair
Dosage of milk either too little or too
Use the dosage of milk according to the
much
dial
Jug reused without cleaning
Actual voltage much lower than
specified voltage
Cleaning in time after use
Use the appropriate voltage
Make sure to use whole or semi-skimmed
Quality of milk froth not
Wrong milk type or temperature
milk at refrigerator
Wrong whisk used
Make sure to use the appropriate whisk
Jug reused without cleaning
Make sure the jug is clean
temperature (about 6-8 °C)
up to
standard
CLEANING AND CARE
1. NOTE: To reduce build-up of milk residue, always empty any residual milk and clean immediately after
frothing is convicted. Never leave liquid in the milk frother overnight.
2. Unplug the power base from the electrical outlet and let the milk frother cool down completely before
cleaning.
3. Clean the inside of the jug with a damp & soft cloth, or sponge. Only the whisk can be detached to rinse
with water.
4. If necessary, put on the whisk attachment to the whisk head. Fill clean water to MAX. level mark, then
add a couple drops of mild liquid soap. Turn the milk frother ON and allow the soapy water to clean the
jug. After the milk frother turns itself OFF, discard the soap water. Pour fresh clean water into the jug
and discard; repeat until soap residue is completely removed. Wipe out with damp cloth.
5. WARNING! Do not immerse the milk frother or the power base in water or any other liquid. Never place
the milk frother under running water to clean. Do not place in the dishwash en.
6. Make sure that all electrical connectors and sockets are kept dry.
7. Rinse lid and whisk in clean water and dry thoroughly.
8. Never use any solvents or abrasive cleaning agents, hard brushes, metal or sharp objects to clean. Solvents
are hazardous to health and harm the product5s plastic parts; abrasive cleaning agents and cleaning
accessories may scratch the product5s surfaces.
9. Any other servicing should be performed by an authorized service representative.
UNPACKING AND CHECKING THE PRODUCT
2.
Remove the product and accessories carefully from their original packaging.
Check whether the contents of the packaging are complete or damaged. If the contents of the packing are
incomplete or if damage is detected, please return the product to us.
3.
No Hazard! Keep packaging materials out of reach of young children.
1.
INTENDED USE
1. This product is suitable for heating and frothing milk only. Any other use may result in damage to product
and/or injuries.
DRY PROTECTION
1. If there isn't sufficient milk in the milk frother, it will shut OFF automatically. Nevertheless, always ensure
that there is enough milk in the product, as switching the device OFF automatically can shorten its life
span.
2. Allow the product to cool down before filling it again.
STORAGE
1. Unplug the milk frother and allow it to cool.
2. Store in its box in a cool and dry place.
3. Never store the appliance while it is still connected to mains power.
4. Never wrap cord tightly around the appliance.
5. Do not put any stress on the cord where it enters the appliance as it may cause the cord to fray and break.
Brand Owner:Shanghai Starship Electronic Commerce Co., Ltd.
Manufacturer:Ningbo Turando Electrical Appliances Co., Ltd.
358 Weisan Road, Andong Town, Hangzhou Bay New Zone, Ningbo, Zhejiang, China
">