Tel: 714.434.6904
Fax: 800.362.0002
• Gate entry system in rugged steel housing (10 gauge)
• Model 302 includes illuminated keypad and controller for 2 gates
(16.5 volt 40VA power supply is included)
• Includes 3.6 mm B&W camera on fixed bracket
• Camera specs:
B&W - 0.1 lux, 400 lines, 3.6 mm lens (standard)
• Camera options:
Color - Sony ExView 1/3” chip, 560 lines, 3.6 mm lens
Min illumination - less than 0.02 lux (optional)
• Camera power supply included
• Includes 7.625” x 4.375” x 7.75” (h w d) steel housing
• Steel housing is metalized (rust proofing) and powdercoated black
• Mounts on pipe gooseneck (optional) or in-wall
• Includes bracket for Panasonic KX-T30865 door box
MODEL 302-CR - Crestron version. Includes C2N-IIF.
MODEL 302-PAN - Compatible with Panasonic KSU’s. Includes
speaker, microphone, and circuit board.
MODEL 302-PAN2 -Includes circuit from Panasonic KX-T7775 (amplified
door station). Adjustable volume control for noisy environments. Includes
Panasonic power module (mounts by KSU), speaker, microphone, and circuit
MODEL 302-TES2 - Telephone Entry System (TES2) creates a
communication link between the front door and every telephone in the house.
Special telephones are not required. Includes relay for gate control.
MODEL 302-VIK - High performance version using Viking components.
System uses “half-duplex” communication, allowing for high speaker and
microphone volume. . OPTION: Upgrade to EWP (Enhanced Weather
Protection) intercom -
MODEL 302-ELN - Compatible with Elan. Includes COM2
door station model DSF3. Option: model DSC3 with balun module MODEL 302-MIT - Compatible with Mitel 3000 telephone systems.
Includes speaker, mic and circuit board from Mitel doorbox.
MODEL 302-OnQ - Compatible with OnQ Cat 5 intercom systems.
Includes speaker, microphone, and circuit board from OnQ F7596.
MODEL 302-45 Ohm -Compatible with Valcom, M&S, and any
intercom using 45 ohm speakers. Includes outdoor treated 45 ohm speaker.
STANDARD FINISHES: polished brass, oil rubbed bronze, brushed chrome, black powdercoat, and brushed aluminum
Allow 3 to 4 weeks for stainless steel or other finishes.
Download PDF