CG-8_PAL_e.fm 3 ページ 2008年5月20日 火曜日 午前9時21分
Before you begin
Thank you, and congratulations on your choice of the CG-8. This leaflet explains how to switch the CG-8’s
video output. Please read it before you start using the CG-8.
To use the RGB output
Make the following setting if you want to use the RGB output.
1 Turn on the power of the CG-8.
2 After the CG-8 has started up, hold down the visual pad [1] button and press and hold the [SHUTDOWN]
button for at least two seconds to shut down the CG-8.
3 When the CG-8 has finished shutting down and is in standby mode, press the [SHUTDOWN] button once
again to restart the CG-8.
4 When the CG-8 restarts, the RGB output will be available for use. This setting will be retained even while the
power is switched off.
Using the video output (Composite or S-VIDEO)
Make the following setting if you want to use the video output (Composite or S-VIDEO).
1
Turn on the power of the CG-8.
2 After the CG-8 has started up, hold down the visual pad [2] button and press and hold the [SHUTDOWN]
button for at least two seconds to shut down the CG-8.
3
4
When the CG-8 has finished shutting down and is in standby mode, press the [SHUTDOWN] button once
again to restart the CG-8.
When the CG-8 restarts, the video output will be available for use. This setting will be retained even while
the power is switched off.
* You can’t use the RGB output and video output at the same time.
Copyright © 2005 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced
in any form without the written permission of ROLAND CORPORATION.
CG-8 LEAFLET PAL
*
4
0
6
7
1
1
2
3
-
0
40671123
2
*
2N
Download PDF

advertising