Specifications — TPS150: TPT150 and TPR150

Specifications — TPS150: TPT150 and TPR150
Video
Gain ...............................................
Crosstalk .......................................
Number/signal type ...................
Connectors ....................................
Unity
-42 dB @ 10 MHz
1 set of proprietary analog signals
1 RJ-45 female jack
Video input
Number/signal type
TPT150 ............................... 1 VGA-UXGA RGBHV with 1 RGB buffered local monitor loop-through
1 VGA-UXGA RGBHV
2 component video (Y, R-Y, B-Y), or S-video, or composite video
TPR150 .............................. 1 set of proprietary analog signals from a TPT150
Connectors
TPT 150 .............................. 2 female 15-pin HD (RGB input)
1 female 15-pin HD (RGB loop-through)
2 sets of [3 female RCA (component video), 1 female RCA (composite),
1 female 4-pin mini DIN (S-video)]
TPR150 .............................. 1 female RJ-45 jack
Nominal level ............................... 1 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for RGB
0.3 Vp-p for R-Y and B-Y of component video, and for C of S-video
Minimum/maximum levels ...... Analog: 0.3 V to 1.5 Vp-p with no offset at unity gain
Impedance .................................... 75 ohms
Return loss .................................... <-40 dB @ 5 MHz
DC offset (max. allowable) ......... ±50 mV
Video output
Number/signal type
TPT150 ............................... 1 set of proprietary analog signals
TPR150 .............................. 1 RGBHV
1 component video (Y, R-Y, B-Y)
1 S-video
1 composite video
Connectors
TPT150 ............................... 1 female RJ-45 jack
TPR150 .............................. 1 female 15-pin HD (RGB)
3 female RCA (component video)
1 female 4-pin mini DIN (S-video)
1 female RCA (composite video)
Nominal level ............................... 1 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for RGB
0.3 Vp-p for R-Y and B-Y of component video, and for C of S-video
± 0.1 Vp-p with 50' of TP cable between the TPT150 and TPR150
Minimum/maximum levels ...... 0.24 V to 1.5 Vp-p
Impedance .................................... 75 ohms
Return loss .................................... -22 dB @ 5 MHz
DC offset ....................................... ±30 mV with input at 0 offset
Sync
Input type .....................................
Output type ..................................
Standards ......................................
Input level .....................................
Output level ..................................
1-2
RGBHV
RGBHV
NTSC 3.58, NTSC 4.43, PAL, SECAM
2.3 V to 4.6 Vp-p, unterminated
3.2 V to 4.6 Vp-p, unterminated
TPT150, TPR150 • Specifications
Input impedance ..........................
Output impedance ......................
Max. input voltage ......................
Max. propagation delay ..............
Max. rise/fall time .......................
Polarity ..........................................
1k ohms
75 ohms
4.6 Vp-p
760 ns
35 ns
Negative
Audio — TPT150 only
Gain ...............................................
Frequency response .....................
THD + Noise ................................
S/N ...............................................
Crosstalk .......................................
Stereo channel separation ..........
-30 dB to +9 dB, adjustable
20 Hz to 20 kHz, ±5 dB
0.04% @ 1 kHz at nominal level
>-80 dB at maximum output
<-80 dB @ 20 kHz, fully loaded
>-70 dB @ 1 kHz
Audio input — TPT150 only
Number/signal type ...................
Connectors ....................................
Impedance ....................................
Nominal level ...............................
Maximum level ............................
4 stereo, unbalanced
4 pairs of RCA connectors
>7.8k ohms unbalanced, DC coupled
2.22 dBu (1 Vrms)
+9 dBu, (unbalanced) at 1%THD+N
0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV
2 dBu
Audio output — TPT150 only
Number/signal type ...................
Connectors ....................................
Impedance ....................................
Gain error ......................................
Maximum level (Hi-Z) ................
Maximum level (600 ohm) .........
1 stereo, balanced/unbalanced
(1) 3.5 mm captive screw connector, 5 pole
51 ohms unbalanced
±0.5 dB channel to channel
>+8 dBu, balanced or unbalanced at 1% THD+N
>+4.2 dBm, balanced or unbalanced at 1% THD+N
Control/remote — transmitter (TPT150)
Serial control port ........................ RS-232, 9-pin male D connector
Baud rate and protocol ............... 38400, 19200, 9600 (default), 4800, 2400, or 1200 baud (configurable); 8 data bits; 1
(default) or 2 stop bits; no parity (default), or even or odd parity
Serial control pin configurations 2 = RX, 3 = TX, 5 = GND
Contact closure ............................ (1) 3.5 mm captive screw connector, 8 pole for a CTP150CM control panel or locally
constructed device
Contact closure pin configurations 1 = input 1, 2 = input 2, 3 = input 3, 4 = input 4, 5 = volume up, 6 = volume down,
7 = projector power, 8 = GND
Program control ........................... Inline Control Software for Windows® – lCS100
Control — projector (TPR only)
Projector control port .................. RS-232, 9-pin male D connector
Baud rate and protocol ............... 38400, 19200, 9600 (default), 4800, 2400, or 1200 baud (configurable); 8 data bits; 1
(default) or 2 stop bits; no parity (default), or even or odd parity
General
Power ............................................. 100 VAC to 240 VAC, 50 to 60 Hz, internal, autoswitchable
TPT150: 9 watts
TPR150: 20 watts
Temperature/humidity .............. Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +104 °F (0 to +40 °C) / 10% to 90%, noncondensing
TPT150, TPR150 • Specifications
1-3
Rack mount
TPT150 ...............................
TPR150 ..............................
Enclosure type ..............................
Enclosure dimensions
TPT 150 ..............................
Yes, with included brackets, part #MTR102
No, but projector pole mountable with included L brackets
Metal
1.7" H x 17.0" W x 11.5" D (1U high, full rack wide)
4.3 cm H x 43.2 cm W x 29.2 cm D
(Depth excludes connectors. Width excludes rack ears. Height excludes rubber
feet.)
TPR150 .............................. 1.7" H x 11.75" W x 6.0" D (1U high)
4.3 cm H x 29.8 cm W x 15.2 cm D
(Depth excludes connectors. Width excludes rack ears. Height excludes rubber
feet.)
Product weight
TPT150 ............................... 5.2 lbs (2.4 kg)
TPR150 .............................. 2.2 lbs (1.0 kg)
Shipping weight ........................... 13 lbs (6 kg)
DIM weight
USA/Canada .................... 11 lbs (5 kg)
International ..................... 12 lbs (6 kg)
Vibration ....................................... ISTA 1A in carton (International Safe Transit Association)
Listings .......................................... UL, CUL
Compliances ................................. CE, FCC Class A
MTBF ............................................. 30,000 hours
Warranty ....................................... 3 years parts and labor
All nominal levels are at ±10%
Specifications are subject to change without notice.
(7.51-020205-D6)
1-4
TPT150, TPR150 • Specifications