Vidikron | Vision 90t | HB050V INSTALLATION INSTRUCTIONS

HB-050V
VIDEO PROJECTOR CEILING MOUNT
FOR VIDIKRON VISION 90, VISION 100,
The Chief HB050V video projector ceiling mount is designed to provide fast, simple and secure installation of the
Vidikron Vision. Special roll, pitch, yaw and horizontal adjustments simplify projection positioning for image
alignment. The HB050V mount also has positive registration lock so that the projector may be removed without
losing projector mount registration.
WARNING: IMPROPER INSTALLATION MAY RESULT IN SERIOUS PERSONAL
INJURY! All components must be securely fastened to each other and to the ceiling, AND
the ceiling MUST be capable of supporting 5 times the total weight of the installation. If it
cannot, the ceiling MUST be reinforced.
Unpack and check contents:
(1)
(1)
(4)
(6)
Deluxe ceiling mount housing assembly.
Vidikron mounting bracket
5/16” Flange Nuts
Nylon Spacer .50” OD X .26”ID X 1.625 TL
(12)
(6)
(6)
#10 washers, flat
10 - 32 x 3/8” Screws, PH, Phillips
10 - 32 x 2” Screws, PH, Phillips
INSTALLATION INSTRUCTIONS
1.
Turn your projector upside down.
2.
Place the (6) Nylon Spacers over the six threaded inserts in the bottom of the projector.
3.
Place the Vidikron mounting bracket on the six nylon spacers on the bottom of the projector. The triangle in
the front center of the bracket should be facing the front of your projector and the six holes in the bracket line
up with the six threaded inserts in the bottom of the projector.
4.
Slide the (12) #10 washers, two on each (6) 10-32 x 2” Screw and install them into the six threaded inserts in
the projector. Securely tighten all six mounting screws at this time.
5.
Be sure that the method of support you are using for the VCM ceiling mount is securely installed to the
ceiling. If not, the ceiling must be reinforced. Improper installation may result in serious personal injury.
6.
Attach the VCM housing to your method of support and tighten firmly so the VCM housing is square to the
screen.
PRECAUTION: Installing a ceiling mount requires the presence of two persons familiar with
mechanical installations. A third assistant is recommended.
6.
With the help of your assistants, lift the projector and install it to the four studs extending from the mounting
plate. Be sure the Vidikron mounting plate is seated in slots. Tighten securely using the (4) 5/16” flange
nuts.
For projector alignment see attached sheet.
8803-000069
CHIEF MANUFACTURING INC. 1-800-582-6480, Fax: 1-877-894-6918, Email: chief@chiefmfg.com
03/02/06
Download PDF