Wisco Industries 621 Manual

MODEL 621 - CONTROL PANEL ASSEMBLY
0027439SK
DESCRIPTION:
This document illustrates how to replace the Control Panel Assembly in your Model 621.
#1
#2
TOOLS NEEDED
• Pliers (Needle Nose Recommended)
• #2 Phillips Head Screwdriver
PARTS INCLUDED
• (1) 0027439SK - CONTROL PANEL ASSEMBLY KIT
Please review this document thoroughly before beginning repairs. Wisco recommends using qualified local service agents. Wisco does not have authorized service agents.
FS14130 - REV: ORIG
Page 1 of 4
MODEL 621 - CONTROL PANEL ASSEMBLY
0027439SK
UNPLUG UNIT FROM OUTLET AND ALLOW TO COOL
1.) Remove the Door. (See door removal instructions)
2.) Remove door gasket. Grab gasket from any corner
and gently pull out to remove.
FS14130 - REV: ORIG
3.) Remove the five screws along the bottom of the Control Panel holding it to the Bottom Panel.
Page 2 of 4
MODEL 621 - CONTROL PANEL ASSEMBLY
0027439SK
#1
#2
#3 #4 #5
4.)Remove the front eight screws of the Control Panel.
Note the smaller sized screws that are located within the
gasket channel.
5.) Use a pliers to carefully disconnect the five wire connections from the Power Board. (Note Position of
each wire)
6.) Assemble in reverse order and unit is ready for
operation.
Wire Connections:
#1 - Neutral
#2 - Line
#3 - Hi-Limit
#4 - Hi-Limit
#5 - Motor
FS14130 - REV: ORIG
Page 3 of 4