stilum Jump circles Mounting Instructions

Mounting instructions bouncing element „jump circleS“
Item no. 51461x170
Diagram 1: Overall view of the play equipment
© stilum GmbH, Gewerbegebiet Larsheck, 56271 Kleinmaischeid • Tel. +49 (0) 2689 92790-0 • All rights and product modifications reserved.
State: 22.01.2019 S. 1
Mounting instructions bouncing element „jump circleS“
Item no. 51461x170
1. Select the play equipment location in consideration of the required
safety area (see diagram 4: Ø 4200 mm).
2. Carry out excavation work for the foundation as shown in diagram 3.
pit size: Ø 1900 x 600 mm
Needed combined frost protection and load bearing layer material:
0,491 m³
Note: Lifting equipment is needed
3. Create combined frost protection and load bearing layer as shown in
diagram 2.
4. Screw the eyebolts into the existing holes and use as lifting point.
5. Lifting Bouncing Element Jump Circle S and place it in the middle of
the pit.
Zeichnung 2: Sickerschicht aus KFT-Material
Diagram 2: Combined frost protection and load bearing layer
Zeichnung 2: Sickerschicht aus KFT-Material
6. Unscrew eyebolts
7. Fill the gap with parts of excavation
8. Think about safety surface
9. For a maximum fall height of 1000 mm safety surface must be according to EN 1176-1 ,chart 4.
For a bouncing element, the extent of the clearance must be 1500
mm horizontally around the jump surface, measured at each point of
the edge, and 3500 mm above the jump surface.
10. Do not allow children to use the equipment before the installation
has been finished.
Zeichnung
3: Schnitt
eingebauten
Sprunggeräts
Diagram
3: Cutdes
through
installed
Bouncing Element Jump Circle S
Zeichnung 3: Schnitt des eingebauten Sprunggeräts
Attention: If the play equipment has been incompletely installed or partly dismantled when carrying out maintenance and repair work, this may
lead to particular risks of injury for the user. For this reason, make clearly
visible that the equipment shall not be used in such cases.
©5stilum GmbH, Gewerbegebiet Larsheck, 56271 Kleinmaischeid • Tel. +49 (0) 2689 92790-0 • All rights and product modifications reserved.
State: 22.01.2019 S. 2
Mounting instructions bouncing element „jump circleS“
4. Dimensions
Item no. 51461x170
Extent of the minimum zone =
safety area
Impact area
Drawing 1: Dimensions impact area
For a bouncing element, the extent of the clearance must be
Diagram 4: Top view
1500 mm horizontally around the jump surface, measured at
each point of the edge, and 3500 mm above the jump surface.
4
© stilum GmbH, Gewerbegebiet Larsheck, 56271 Kleinmaischeid • Tel. +49 (0) 2689 92790-0 • All rights and product modifications reserved.
State: 22.01.2019 S. 3