Sunjoy Sonoma L-GZ815PST-BR Owner's Manual

Sunjoy L-GZ815PST-BR Sonoma Wicker Gazebo
Owner’s Manual
IMPORTANT
Thank you very much for choosing Sunjoy Group.
Please take time to read these instructions thoroughly and follow each step carefully for safe and easy
operation. Keep this manual for future reference.
We would like to hear from you with any comments or suggestions. You can call us toll-free at
1-866-578-6569 from 8:00 a.m. EST to 8:00 p.m. PST. You can also send the email to
[email protected] or visit www.sunjoyonline.com to get tech. assistance or to place your
replacement part order form.
Cautions:
1. Keep all children and pets away from assembly area. Children and pets should be
supervised when they are in the area of gazebo construction.
2. The area for assembly should not be less than 6 feet from any obstruction such as fence,
garage, house, overhanging branches, laundry line or electrical wires.
3. This unit is heavy. Do not assemble this item alone. Four people are recommended for safe
assembly.
4. Some parts may contain sharp edges. Wear protective gloves if necessary during assembly.
5. When assembling and using this product, basic safety precautions should always be
followed to reduce the risk of personal injury and damage to equipment. Please read all
instructions before assembly and use.
6. For outdoor use only. Install on level ground. Do not cook inside the tent.
7. Check all bolts for tightness before and during usage
8. Pegs supplied must be used to hold this gazebo in place when upright.
9. WARNING: Please take down the gazebo during strong wind. The manufacturer or retailer
is not liable for any loss of the product or other items due to the failure to take down the gazebo
during strong wind.
10. Do not use candles, matches or open flames of any kind in or near a tent.
11. Build campfires downwind and several meters away from a tent and be sure to fully
extinguish campfires before leaving a campsite or before retiring for the night.
12. Do not climb on top of the gazebo. Falling off the gazebo can result in serious injury
13. Extinguish or turn off all lanterns before going to sleep. Do not smoke in a tent.
14. KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent is
made of flame-resistant fabric. It is not fireproof. The fabric will burn if left in continuous
contact with a flame source.
Assembly Instructions:
Our clear, easy-to-follow, step-by-step instructions will guide you through the project from start
to finish.
Loading limit of the hook is 26 lbs.
Parts identification: For ease of identification, all parts are labeled to correspond to the Step
number in which the part is used.
Part List
Post
A
4
Long horizontal screen 1
B
2
Long horizontal screen 2
C
2
Short horizontal screen 1
D
2
Short horizontal screen 2
E
2
Cant beam
F
4
Long middle beam
G
2
G1
2
H
2
H1
2
Cant beam down tube
I
4
Big top connector
J
1
Small top cant beam
K
4
Cant beam down connector
L
4
Middle beam down connector
M
4
Small top connector
N
1
Finial
O
1
Hook
P
1
Ferrule
Q
4
Long mosquito netting tube
R
4
Short mosquito netting tube
S
4
Small canopy
T
1
Big canopy
U
1
Mosquito netting
V
1
Curtain
W
1
Long middle beam down
connector tube
Short middle beam
Short middle beam down
connector tube
Hardware Pack 1
`
AA
M6x20 Bolt
72 PCS
BB
M6 Washer
80 PCS
FF
M6x20 Screw
8 PCS
Z
Wrench
2 PCS
Fig.1 Attach long horizontal screen 1 (B) to
long horizontal screen 2 (C) by bolt (AA),
washer (BB) and nut (DD). Attach long screen
(B &C) to middle beam down connector (M)
by bolt (AA) and washer (BB). Use the same
way to attach short horizontal screen.
Fig.2 Attach screen (B, C, D and E) to post
(A) by bolt (AA) and washer (BB).
Fig.3 Attach cant beam down
connector (L) and mosquito
netting tube (S&R) to post (A)
by bolt (AA) and washer (BB).
Fig.4 Attach mosquito netting tube
Fig.4-1 Attach ferrule (Q)
(R&S) to horizontal screen by bolt
screen
(AA) and washer (BB).
screw (FF).
(B&C,
D&E)
Hardware Pack 2
BB
M6 Washer
16 PCS
EE
M6*35 Screw
8 PCS
DD
M6 Nut
8 PCS
Fig.5-1: Insert long middle beam
Fig.5-2 Attach hook (P) to big top
Fig.6 Attach middle beam (G1,
(G) into the tube of long middle
connector (J) and then insert
H1) to middle beam down
beam down tube (G1). Use the
long middle beam (G) and short
connector (M) by screw (EE)
same way to attach H1 and H.
middle beam (H) into big top
and washer (BB).
connector (J).
by
Fig.7 Insert cant beam (F)
Fig.8 Insert the other end of
Fig.9 Attach cant beam down tube (I) to
into cant beam down tube
cant beam (F) into big top
cant beam down connector (L) by screw
(I).
connector (J).
(EE), washer (BB) and nut (DD).
Fig.12 Attach the finial
Fig.13 Put the big canopy
onto the small top and
(O)
(U) onto big top and do
attach four corners of
connector (N).
Fig.10 Attach small cant
Fig.11 Put small canopy (T)
beam (K) into small top
connector (N).
to
small
top
not spread out. Then
small canopy to small top
insert
the
assembled
cant beam (K).
small top into big top
arch beam (F) through
small top arch beam (K).
Hardware Pack 3
GG
Plastic ring
104 PCS
HH
Stake￠6X230
12 PCS
Fig.14 Spread big canopy (U) and
Fig.15 Hang mosquito (V) and
Fig.16: Fix the gazebo to lawn by
attach four corners to cant beam
curtain (W) onto netting pipe
stake (HH).
down tube (I). Stick hook-and-loop
(R, S) by plastic ring (GG).
fasteners.
Now Gazebo is now ready for use.
Care & Maintenance:
Our steel components for garden accessories and furniture are treated with rust inhibiting paint
that protects it from rusting. However, due to the nature of steel, surface oxidation (rusting) will
occur once these protective coatings are scratched. This is not a defect and thus not covered
by the warranty.
To minimize this condition, we recommend care when assembling & handling the product to
prevent scratching the paint. Should any scratching or damage occur, we recommend
immediate touch-up with rust inhibiting paint.
Surface rust can also be easily removed with a very light application of common cooking oil. If
surface oxidation (rusting) occurs and if no measure is taken to prevent this, the oxidation may
start dripping on to deck or patio and caused damaging stains, which may be difficult to
remove. This can be prevented if the above-mentioned measures are taken to keep the
product from oxidizing.
Limited Manufacturer’s Warranty:
This limited warranty is extended to the original purchaser and applies to defects in materials
and workmanship of your item provided the item is maintained with care and used only for
personal, residential purposes.
The item is warranted to be free from defects in material or workmanship for a period of one (1)
year. We don't reimburse for transportation or delivery costs, or compensate the individual or
any outside party for assembling or disassembling the product.
Exclusions:
Items used for commercial, contract, or other non-residential purposes, or items damaged due
to acts of nature, vandalism, misuse, or improper assembly are not covered. Corrosion or
rusting of hardware is not covered. Proof of purchase (dated register receipt) is required for
warranty claims. Warranty is to the original purchaser and is non-transferable. Any
replacement of warranted items will be in the original style and color, or a similar style and
color if the original is unavailable or has been discontinued. As some states do not allow
exclusions or limitations on an implied warranty, the above exclusions and limitations may not
apply. This warranty gives you specific rights, and you may also have other rights, which vary
from state to state.
Made in China