Xtend Porch Setup Instructions

Setup Instructions
Porch
O U T D O O R S
STEP 1
INCLUDED IN KIT:
Ground Pegs
3x
Spreader Bar
4x
9ft Pole
1x
C-Clip Rafter
C
C
4x
6x
Sprung Guy Ropes
1x
Canopy
STEP 2
Slide the canopy into the sail track on the anti-flap kit.
Fully extend your awning so the sail track groove in the
awning barrel is in the 3 o’clock position and attach the anti-flap kit.
STEP 3
Feed the canopy into the sail track on the other side of the anti-flap kit.
AWNING
ANTI-FLAP KIT
AWNING
ANTI-FLAP KIT
CANOPY
STEP 4
Measure out and extend the spreader bars to fit the awning canopy holes.
CANOPY
STEP 5
Feed the spreader bars (x3) into the pockets on the underside
of the canopy.
CANOPY
CANOPY
POCKETS
POCKETS
POCKETS
SPREADER BAR
www.xtendoutdoors.com.au
SPREADER BAR
1300 783 776
Setup Instructions
Porch
O U T D O O R S
STEP 6
Adjust 4x 9ft poles to the same height as the rear of the anti-flap kit,
and front of the anti-flap kit.
STEP 7
Insert the 9ft pole spigot through the eyelets on the two spreader bars
and through the canopy corner eyelet. Repeat for all bars.
CANOPY CORNER EYELET
Rear of anti-flap
kit height
STEP 8
Raise the porch and adjust the poles and spreader bars until all are tight.
STEP 10
Attach C-Clip rafter between the front and rear spreader bars, and
adjust the length using the handle on the C-Clip rafter.
FRONT SPREADER
BAR
C-CLIP RAFTER
CANOPY
REAR SPREADER
BAR
www.xtendoutdoors.com.au
1300 783 776
PO
9ft
S
STEP 9
AR
RB
DE
EA
AD
E
PR
R
BA
R
SP
ER
LE
Front of anti-flap
kit height
Secure the springs to the ground with pegs and attach rope loops over
9ft pole spigots on the top of your porch.
Tighten by pulling the wooden handle.
Your porch is now ready to use.