Weco G5 Series User Manual

DOOR DETECTOR G5 SERIES
WITH POWER SUPPLY
USER MANUAL
Version UM.G5.PWS
INSTALLATION INSTRUCTIONS
1. Securely fix the transmitter and receiver to the car/car doors through
the fixing holes with the bolts provided, ensuring that the labels are
pointing outwards.
2. Ensure that both the receiver and the transmitter are at the same level.
3. Fix the power supply on the car top. Ensure that the steel cover is grounded.
4. Connect the power supply to the input terminals. Connect the output signals to
the output terminals.
5. Connect the cables from the receiver and the transmitter to the input terminals
of the door controller. Ensure that both cables can be easily and smoothly bent.
Tightly lock both sides of the intermediate connectors.
6. Switch on the power.
The yellow LED in the receiver will light up.
The red LED in the receiver will light up when the light beams are interrupted.
Please ask us about our range of fixings clips and brackets.
TROUBLESHOOTING
Neither LED in the receiver is lit.
The cable is broken or not connected.
Both the yellow and red LEDs of the door
detector are lit without interruption
between the RX and TX.
The plastic filter is too dirty.
Other infrared equipment is nearby.
The ambient light is stronger than allowed.
There is a system fault.
I LED si accendono correttamente
quando vengono interrotti, ma la
porta di cabina non si apre.
Wrong connection with NC/NO contacts.
The output relay is broken.
Check the wiring.
The green LED in the power supply
is not lit.
The power supply wires are broken or
incorrectly connected.
The terminal connection is too loose.
The power supply is broken and needs
to be replaced.
Power Supply LEDs
Door Detector LEDs
NOTES AND ADVICE
· Keep connection cables away from high voltage and/or high current wires.
· Keep connection cables away from door motor and door drive.
· Avoid direct sunlight or other infrared ingress to the receiver (RX).
· Prior to power-on, clean the lenses with a soft, damp cloth.
· Do not bend or twist the edges, and do not scratch the lenses.
PLANNED MAINTENANCE PROCEDURE
· Ensure that the yellow LED is lit (system functioning), then clean the lense with a soft,
damp cloth.
· Check all plug and terminal connections.
· Perform a detection test by inserting an object greater than 50mm between the TX
and RX.
· The red LED status indicator will light to confirm object detection.
POWER SUPPLY
03.G5.PWS.FED.24AD
MODEL NO.
03.G5.PWS.FED.24AD
DC INPUT VOLTAGE
11-35VDC
AC INPUT VOLTAGE
10-24VAC
1
2
3
4
NC NO COM Status
5
7
6
- AC/DC +
Buzzer Function
SW1
Buzzer functions
ON
Buzzer on
OFF
Buzzer off
SW2
Buzzer delay
ON
Delay 20s
OFF
Delay 30s
SW3
Buzzer active
ON
Infinite
OFF
60s
SW4
Buzzer setting
ON
Intermittent
OFF
Costant
WARNING
· This equipment should be installed by qualified technicians.
· Follow the instruction of this manual.
· Do not drill the PCB.
PACKING LIST
Please check if anything is missing
from the packing list.
Contents may slightly according to
the customers specific requirements.
Power supply
Cables
1
2 cavi
Transmitter (TX)
1
Receiver (RX)
1
Operation manual
Mounting accessories
1 copia
1 kit
MADE IN P.R. CHINA
[email protected]
www.wecoitaly.com