Unitech WD200 Quick Start Manual

Package
- WD200 Wearable Terminal -
Please make sure the following contents are in the WD200 gift
box. If something is missing or damaged, please contact
your unitech representative.
The package contents

WD200

USB Type C Cable

Quick Start Guide

Regulatory Compliance Statements
Optional accessories

4 slot cradle

EZ Lock arm strap Holder

Wrist Holder

Necklace Holder

Belt Holder

USB 3.0 Cable
Quick Start Guide
608901G V1.0
Product View
1
Power Key
6
Speaker
2
Camera & LED Flash Light
7
Pogo pin
3
Programmable Button / Camera Button
8
USB Type C Port
4
SIM Card Slot
9
Touch Panel
5
LED Light
10
∆ : Back Button
О : Home Button
: Recent Button
11
Microphone Holes
Charging the battery
Inserting a Nano SIM Card
Connect the type C USB cable to the USB port on WD200 and connect
1. Remove the one screw on the Nano SIM card slot cover with a
the other end of the USB cable to AC power adapter. Then plug into the
screw driver and remove the cover.
electrical outlet. It is highly recommended that using the unitech USB
2. Insert the SIM card with the notched corner.
type-C cable to charge the terminal.
3. Push the card into the slot until you feel the card click into place.
4. Lock the cover back into place.
The charging LED indicator on WD200 is turning red when it is in
charging state. The green light is on after the battery is fully charged.
WARNING!
DO NOT force opening the battery cover and attempting to change the battery as you may
damage the product and the battery, it is built-in and is not user changeable.
Checking LED Status
Any batteries inappropriate use could result in damage or safety issues such as catching fire, or
LED
Red Light
Description
￭ Battery Charging
￭ Twinkling to indicate battery
low status(less than 15%)
Green Light
￭ Battery Fully charged
￭ Barcode scan good read
Blue Light
Message
No LED (Red and Green) display when battery is out(even AC IN)
malfunctioning the sensitive components. unitech reserves the right and disclaims any liability as a
result of any damages caused by ignoring this warning. To avoid any consequential damages,
please contact a unitech representative before removing the battery.
WARNING!
There is a risk of fire and burns if the battery is handled improperly. DO NOT disassemble, crush,
puncture, short external contacts, or dispose the battery pack in fire or water. DO NOT attempt to
open or service the battery. Dispose of used batteries according to local recycling guidelines in
your area.
CAUTION!
￭ To ensure the unit working properly, please keep all connectors away from the contaminants
staying inside of them such as dust, grease, mud, and water. The negligence may cause the
unit with no communication, short circuited, overheated and so on.
For other product documentation, please scan the QR code below for more information.
￭ If the connector is damaged, please ensure the connector is being fully repaired before using the
unit to avoid causing short circuited.
http://www.ute.com/
Copyright 2021 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.