Vinson Acoustics VA IW6 Manual
The Vinson Acoustics VA IW6 is a 6 ½” 2-Way In-Wall Speaker designed for versatile installation. It features an impressive frequency response of 46Hz - 20KHz, delivering clear highs and powerful lows. The speaker is capable of handling 50-100 watts at 8 ohms, making it suitable for a range of audio systems. Ideal for both vertical and horizontal mounting, it offers flexibility in placement. The robust aluminum driver and silk/titanium tweeter contribute to its exceptional sound quality.
advertisement
▼
Scroll to page 2
VA IW6 6 ½” 2-Way In-Wall Speaker -4www.vinsonacoustics.com www.vinsonacoustics.com Specifications • • • • • • • • • 6 ½” Aluminum Driver ¾” Silk and Titanium Tweeter Frequency Response: 46Hz - 20KHz 46Hz +/- 20%Hz without baffle Power Handling: 50- 100 watts @ 8 ohms Mounting: vertical or horizontal Magnet Size: 3.1 " x 1.5" x 0.59" Magnet Weight: 10 oz Temperature range: 14°F-149°F Installation Instructions Choosing the Location: • The mounting surface should be between 1.2" and 3.7" thick, and with at least 3.7" clearance behind the mounting surface and no wall studs or other objects to block the back of the speaker. • Use the "speaker cutout template" to mark the location for mounting the speaker. Preparing the Speaker: • If you want to paint the plastic frame & grille, paint them before connecting the speaker wire or mounting the speaker. • Use care when removing the speaker grilles from the micro-flange as they fit very tightly. Excessive force may cause damage to the speakers, grilles, and/or the speaker frame. • When painting the frame, remove the grille and insert the supplied cardboard paint mask to prevent the paint from entering the speaker. Connecting the Speaker Wires: • Route the speaker wire from the receiver to the speaker. • Separate about 4" of speaker wire at each conductor end. • Using a wire stripper, remove about 6mm (1/4") of insulation from each wire. • Twist the ends of each wire to prevent fraying. • Connect a marked wire to a red speaker terminal by pressing the release tab, inserting the wire into the hole, and then releasing the tab. Repeat this procedure to connect the unmarked wire to the black terminal. • Connect the marked wire coming from the speaker's red terminal to the red or positive ( + ) terminal on the amplifier, then connect the unmarked wire coming from the speakers black terminal to the black or negative (-) terminal on the amplifier Mounting the Speaker • Carefully remove the speaker grille to expose mounting screws. • Be sure the mounting tabs are turned inward, then place the speaker into the mounting hole. • Using the 4 supplied screws, tighten the mounting tabs until the speaker is mounted firmly. • Replace the grille -2www.vinsonacoustics.com -3www.vinsonacoustics.com
advertisement
Key Features
- 6 ½” Aluminum Driver
- ¾” Silk and Titanium Tweeter
- Frequency Response: 46Hz - 20KHz
- Power Handling: 50- 100 watts @ 8 ohms
- Vertical/Horizontal Mounting
- Easy Installation
Frequently Answers and Questions
What is the minimum and maximum thickness for the mounting surface?
The mounting surface should be between 1.2” and 3.7” thick.
How much clearance is required behind the mounting surface?
At least 3.7” clearance is required behind the mounting surface.
Can I paint the speaker frame and grille?
Yes, you can paint the plastic frame and grille before connecting the speaker wire or mounting the speaker. Make sure to use a paint mask to prevent paint from entering the speaker.
Related manuals
Download
PDF
advertisement
