Advertisement
Advertisement
52103 13” Reversible Electric Cooling Fan-12volt, 160w motor Mounting Instructions; Using Tie Kit 1. Assemble mounting brackets to fan by tapping into place with a rubber or plastic hammer. 2. Peel backing and stick 4 spacers on fan shroud as shown in fig 1.Install the remaining 4 spacers on the tie straps as shown. 3. Position fan on heat exchanger. 4. Make passageway through heat exchanger fins using #1 phillips screwdriver. Use hand pressure only, insuring the heat exchanger is not damaged. 5. Slide the tie strap through the mounting bracket, spacer, and heat exchanger as shown. Secure with plastic lock on opposite side of the heat exchanger as shown. 6. Fuse Fan To 20 Amps. Recommended Fuse Type Is SAE ATC/ATO. Recommended Wire Gauge Is 14. ADHESIVE SIDE MOUNTING BRACKET TIE STRAP PLASTIC LOCK SPACER SPACER RADIATOR PLACE ONE SPACER IN EACH CORNER, REPEAT ON OPPOSITE SIDE FIGURE 1 FIGURE 2 RECOMMENDATIONS: It is the installer’s responsibility to determine suitability for the individual application. It is recommended to periodically check the fan to make sure it has not become loose which can lead to damage of the heat exchanger. We provide tie kits with all of our fans. However, for optimum mounting strength and performance we recommend using the Jegs 555-52120 mounting kit on fans larger than 12” and/or 130 watts nominal. Reversing Instructions: 1. Disconnect power to the fan. Remove clip as shown. Clockwise as shown. Figure 3 2. Carefully pull the blade off the motor shaft. Caution - edges of blade are sharp. Do not try to drive the motor out by impact! This will destroy the motor and void the warranty. Flip the blade, then place back on the unit by lining up the hub center with the motor shaft. Blade will rest on spacers as shown in figure 4. Be very carefull not to loose any of the spacers. 3. After seating blade, replace clip. Pusher configuration should look as shown in figure 5. Note: Fan wiring changes to black (+) POS and Blue (-) NEG. ROTATION ROTATION INNER DRIVE PLATE PULLER PUSHER WIRING: BLACK (+) POS BLUE (-) NEG WIRING: BLUE (+) POS BLACK (-) NEG SAFETY CATCH ON CLIP SHOWN CORRECTLY SEATED BETWEEN RETAINING WALLS OUTER DRIVE PLATE CLIP LIFT THEN PUSH FIGURE 3 FIGURE 4 1-800-345-4545 FIGURE 5 jegs.com TA9000959 rev_1 ">

Public link updated
The public link to your chat has been updated.
Advertisement