JEGS 60200-01 CO2 Regulator Installation Instructions 1 Pages

advertisement

Ask Al about JEGS 60200-01 CO2 Regulator Installation Instructions

Chatbot has read manual and is ready to answer your questions.

Manual
JEGS 60200-01 CO2 Regulator Installation Instructions | Manualzz
Installation Instructions for 60200 & 60201
CO2 Regulator with Dual or Single Gauge
Installation Instructions:
1. Make sure the bottle valve is fully closed.
2. Select a position for the bottle and regulator that allows good visibility and is the least prone to vibration.
3. Insulate the mount from the frame or sheet metal to minimize vibration. Doing so will increase the life
expectancy of the gauges.
4. Install the Quick-Push style fitting without adding a thread sealer (it already has a sealant applied). The QuickPush fitting can be tightened by inserting a 5/32” hex wrench into the inside of the fitting or using a wrench.
5. Thread the regulator onto the bottle. Rotate the head of the unit away from any obstructions or potential
vibrations and into a clearly visible position to read the gauges.
6. Tighten the regulator mounting nut.
7. Insert your Quick-Push line into the fitting by depressing the small yellow tab on the outside of the fitting. Push
the line, which should be squarely cut, into the fitting until you feel resistance (bottoms out). Release the tabs.
The line should now be firmly sealed.
8. Open the bottle valve so it is fully open.
9. Open the regulator by turning the t-style handle to the left.
a. Adjustment of the regulator on the dual gauge unit is performed by turning the t-handle adjuster in
either direction until the proper pressure is achieved. The left gauge will display line pressure while
the right gauge will display the bottle pressure.
b. The single gauge unit is pre-set @ 85psi (+/- 5psi).
1-800-345-4545 jegs.com

advertisement

Related manuals

Download PDF

advertisement