DOMUS Dusk MR16 LED Garden Spike Light Instruction manual

29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia
Phone: 02 9554 9600 | Fax: 02 9554 9433
[email protected] | www.domuslighting.com.au
Installation Manual
DUSK SPIKE MR16
Date: December 14, 2023 1:24 PM
Specifications
Voltage:
12V DC
Lumen (±5%):
Power:
IP Rating:
CRI:
Requires:
6W
Beam Angle:
IP65
CCT:
≥80
Lifespan:
12V DC Constant Voltage LED Driver (Wire in Parallel)
Warm White 3000K - 500lm
Neutral White 4000K - 550lm
White 6500K - 550lm
60°
3000K-4000K-6500K
50,000hrs
Save these instructions
Warning - To reduce the risk of fire or injury to persons:
•
•
•
•
•
•
Turn power off or unplug the luminaire and allow it to cool before replacing the lamp
Lamp gets hot quickly. Contact only switch/plug when turning on.
Do not touch the hot lens, guard or luminaire housing until it has cooled
Keep Lamp away from combustibles.
Do not touch lamp. Use a soft cloth. Oil from skin may damage lamp.
Do no operate the luminaire fitting with a missing or damaged shield.
Important Safety Instructions
• For outdoor use only
• Make sure the power is turned off before installing or servicing the luminaire.
• WARNING: Risk of electrical shock. Install all luminaires 3.05m or more from a pool, spa or fountain.
• Position the wire and wire connector so that it is connected within 15.2 cm from a building or structure, a luminaire or fitting.
• Not to be buried except for a maximum of 15.2cm to connect to the main low voltage cable.
Lamp Installation/Replacement Instructions
•
•
•
Unscrew the shroud from the fixture housing.
Insert the MR16 LED lamp with correct wattage as marked on the fixture label.
Replace shroud and twist shroud in place.
Shroud
Glass
LED Lamp
Sealing Ring
Housing
Note:
-The lamp must be installed by professional electrician
-Ensure the power supply is switched off before fitting this product
-Do not touch the lamp when in use
-Keep away from hot steam and corrosive gas
29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia
Phone: 02 9554 9600 | Fax: 02 9554 9433
[email protected] | www.domuslighting.com.au
Installation Manual
Fixture Mounting Instructions
•
•
•
•
•
•
•
•
Disconnect transformer from main power supply.
Remove shroud from the fixture housing
Insert MR16 LED Lamp (10W max) into the lamp socket.
Replace shroud and secure with twisting motion
Run lead wire from the fixture through the ground stake mounting hole.
Insert composite ground stake in desired location until flange of stake is flush to grade.
Screw fixture into top of stake and tighten until snug.
Strip the two fixture lead wires and connect them to the main low voltage supply cable lead with silicone filled wire connectors.
Housing
Adjustable Knuckle
Shroud
Main Supply Cable
Note:
-The lamp must be installed by professional electrician
-Ensure the power supply is switched off before fitting this product
Ground Stake
-Do not touch the lamp when in use
-Keep away from hot steam and corrosive gas
">