In the box, you’ll find:
HeatPulse Knee Massager
(comprising custom-fit sleeve and detachable control pod)
Extension strap
(for using the HeatPulse on the shoulders)
Manual
USB-C
charging cable
Specifications
Control pod
Sleeve
Magnetic back
360° Silkro™ fabric
Breathable, moisture-wicking
polyester mesh lining
Top strap: 51cm (20")
Bottom strap: 48cm (19")
Extension strap: 58cm (23")
HeatLast™ infrared
graphene band
with dual vibrating
cores
Silkro™ fabric
Control pod
Battery capacity:
1600mAh 7W 5V
Battery life:
60-90 minutes
Getting started
1
Find your fit
Strap the sleeve around your knee. It should fit snugly—not too
loose or too tight.
2
Attach the control pod
Attach the magnetic control pod to the sleeve. The control
pod may be attached the right side up or upside down.
If an "E2" error message appears on the display, the control
pod is not properly attached to the sleeve. Simply remove
the control pod and reattach it securely to the magnetic
pad to restart.
3
Turn on the control pod
Press and hold the power button for three seconds. This will
activate the HeatLast™ infrared graphene heating band which
will start to warm to 40°C (104°F)
3s
4
Select your temperature
Push the + button to gradually increase the temperature until
it is right for you. Try each of the five temperature settings for
a few seconds to determine if it’s right for you.
1
2
3
5
Select your massage speed
If you wish to turn on the HeatPulse’s massage function, press
and hold the M button for three seconds. Push the M button
again to cycle through the three speed settings until you find
the one that’s right for you.
Blue light on M button
Speed 1
Green light on M button
Speed 2
White light on M button
Speed 3
(Flashing red light on M button indicates low battery.)
6
Lock in your settings
If desired, press and hold the M button for two seconds to lock
in your current settings. The M button will turn red when the
screen is locked. Press and hold the M button for another two
seconds to unlock.
2s
7
30 min
Enjoy a full treatment session, or turn off
your device
Once you’ve selected your settings, sit back and let the
HeatPulse work its magic. One full treatment session lasts
for 30 minutes, after which the HeatPulse will shut off
automatically. (To end your treatment mid-session, press
and hold the power button for three seconds.)
Repeat the treatment session on the other knee if desired.
The HeatPulse can provide at least two 30-minute sessions
on a full charge.
Charging your HeatPulse
To charge, turn off the control pod
and connect your USB-C charging
cable to the control pod. The pod
can be charged while it is either
attached to or detached from the
sleeve.
2-3 h
M
Low battery
M button will display a flashing
red light and device will beep
three times
Charging
M button will display a
flashing green light
Fully charged
M button will display
a green light
The recommended charging time
is two to three hours for a full
charge. Frequent overcharging
may deteriorate battery
performance and lifespan.
Do not operate the HeatPulse
while it is charging.
Caring for your
HeatPulse
>0%
Control pod
M
Wipe down with a slightly damp or dry cloth. Make sure
the pod is completely dry before attaching it to the sleeve
and turning it on.
Sleeve
It is not recommended to
deplete the battery before
charging. Charge it at any level
and stop once it is fully charged.
Wipe down with a slightly damp cloth or sanitize with
alcohol sprays or wipes. Do not soak, wash, or submerge
in water. Air dry after cleaning and make sure the sleeve is
completely dry before attaching the pod and turning it on.
When to use your HeatPulse
The HeatPulse is designed for:
Knee arthritis
Relieve chronic knee stiffness and pain
Improve blood flow to ease age-related joint tension and
increase flexibility
Knee injuries and
post-surgery recovery
Speed up healing of acute knee pain
High-impact sports
Speed up post-exercise recovery
Heal damaged tissues by increasing blood flow in the knee,
delivering more oxygen and nutrients to the damaged ligaments
Manage overexertion of knee joints after high-impact activity
To maintain the health
of your knee joint, boost
recovery and keep pain
away, use the HeatPulse
Knee Massager once or
twice daily on both knees
(one cycle of 30 minutes
per knee at a time).
For best results, do not
stand up or walk around
while the HeatPulse is
operating. Remain seated
or inclined with your knee
slightly bent to align with
the shape of the sleeve.
The HeatPulse is not a
compression sleeve or
knee brace.
Additional uses:
On elbows
Strap the HeatPulse onto your
elbows, ensuring that it is snug
but not too tight.
On shoulders
The HeatPulse comes with
an extension strap to secure
it around the torso while it is
being used on the shoulders.
Simply attach the extension to
the top strap and wrap it around
the torso under the armpit to
secure the HeatPulse. Secure
the bottom strap around your
tricep and operate as usual.
Safety first
1
2
3
If you feel pain or extreme discomfort,
or notice any skin issues or irritation
around your knee while using the
HeatPulse, stop using it immediately
and consult your physician.
You may notice slight redness on the
knee area while using the HeatPulse.
This is due to increased blood
circulation to the skin from the heat
and vibration, and should not be a
concern. However, if symptoms persist
without relief, consult your physician.
Do not use the HeatPulse excessively.
We recommend using it once or twice
daily (one cycle of 30 minutes per knee
at a time).
4
Do not use the HeatPulse over thin
fabrics like stockings. For best results,
use it directly on the knee and not over
other fabrics.
5
Keep away from children and
infants to avoid injury from
improper use.
6
Do not use the HeatPulse in the
bathroom or shower.
7
Do not use while sleeping.
Consult your physician before using
the HeatPulse if any of the following
applies to you:
• Nerve disorders in the leg
8
Do not use while under quilts
or blankets as this may cause
overheating.
• Skin sensory disorders
• Loss of sense of temperature
• Sensory impairments caused by diabetes
• Heat sensitivity
9
10
• Leg or knee sequelae due to traffic
accidents, etc.
Do not place heavy items or load on
the HeatPulse as this may damage
the components.
• Leg disease (tendon injuries, arthritic
deformities, fractures, varicose veins, etc.)
Do not leave the components
exposed to direct sunlight as they
may overheat and damage the
electronics in the pod and sleeve.
• Malignant tumors
• Implanted medical electronic devices that
are susceptible to electromagnetic failures
such as pacemakers
• Metals, plastic or silicon injected
into the knee from surgery
• Heart disease
• Osteoporosis
11
Do not disassemble the pod or the
sleeve or throw them into fire. This
may cause damage to the product
and the lithium battery.
• Fractures, sprains, or other acute injuries
• Symptoms such as acute inflammation,
fatigue, chills, and blood pressure
fluctuations
• Early stages of pregnancy or recently
given birth
Take your HeatPulse
experience to the next level
Round out your recovery routine—use the HeatPulse Knee Massager
with these complementary products:
The Thermosleeve
Try hot and cold contrast therapy for comprehensive
knee pain relief:
A 360° Hot/Cold Compression
Sleeve that uses Hot or Cold
Therapy combined with
Compression Therapy to help
relieve pain instantly. The
Thermosleeve is fuss-free and
mess-free. Simply take it out
of the freezer or pop it into the
microwave for one minute and
slip it on.
Use the Thermosleeve straight
out of the freezer for cool
relief of acute swelling or pain,
and to reduce inflammation
Use the HeatPulse to relax
muscles and relieve joint
stiffness, soreness, and pain
The Hydragun
Try the Hydragun for whole-body relief and relaxation:
Named “The Quietest Massage
Gun” by Forbes, GQ, TechRadar
and many more, the Hydragun
uses percussive therapy to
knead away tight knots and
aches on targeted muscles.
Use the HeatPulse on the
knees and other joints
Use the Hydragun on all major
muscle groups, including the
neck, shoulders, chest, back,
glutes and thighs
thehydragun
thehydragun
[email protected]
hydragun.com
">
