Bryant | HRVBBSVA1100 | Installation Instructions KVBCN0101BLT WALL

KVBCN0101BLT
WALL CONTROL INSTALLATION
Installation Instructions
MAX
MIN
INTERMITTENT
OneTouch Control
!
NOTE: If this wall control is installed with any of the following
Bryant units the integrated control of those units must be turned
OFF; HRVBBSHA1100, HRVBBSVA1100, ERVBBSHA1100,
or ERVBBSVA1100, HRVBBLHA1150, HRVBBLHA1250.
WARNING
ELECTRICAL SHOCK HAZARD
Failure to follow this warning could result in personal
injury or death.
NOTE: To ensure proper operation remove Jumper G on JU1 pin
IF this wall control is installed with another ERV or HRV Bryant
unit.
Before installing, modifying, or servicing, main electrical
disconnect switch must be in the OFF position. There
may be more than 1 disconnect switch. Lock out and tag
switch with a suitable warning label.
!
!
CAUTION
UNIT OPERATION HAZARD
CAUTION
Failure to follow this caution may result in equipment
damage or improper operation.
Ensure that the wires do not short-circuit between
themselves or by touching any other components on the
wall control. Avoid poor wiring connections. To reduce
electrical interference (noise) potential, do not run wall
control wiring next to another control contactor or near
light
dimming
circuits,
electrical
motors,
dwelling/business power or lighting wires, or power
distribution panels.
UNIT OPERATION HAZARD
Failure to follow this caution may result in equipment
damage or improper operation.
Never install more than one KVBCN0101BLT wall
control per unit.
1
Mode
Suggested Use
Green
Intermittent
Select this mode when you are away from the house for a few days, or when
you deem the inside air is too dry in heating season or too humid in cooling
season. In this mode the unit is OFF for 40 minutes per hour and ventilates at
minimum speed the remaining 20 minutes of the hour.
Yellow
Minimum Speed
Ventilation
For normal daily operation
Red
Maximum Speed
Ventilation
For excess pollutants and humidity
(Parties, odors, smoke, etc.)
KVBCN
Color
2 3/8 in.
INSTALLATION
1 3/8 in.
Step 1—Cut a 2 3/8 in. high by 1 3/8 in. wide hole in the wall.
See Fig. 1.
Step 2—Temporarily place the switch in the hole to mark the
correct locations for the 2 wall anchors.
Step 3—Remove the switch, drill the 2 wall--anchor holes and
insert the wall anchors into the wall.
A05294
Step 4—Using Fig. 2 as a guide, connect the electrical wiring.
Fig. 1 -- Wall Control Installation
Step 5—Finish mounting KVBCN0101BLT wall control. Plug
the unit in and test the wall control operation.
NO C NC I OC OL Y R G B
Y
G B
KVBCN0101BLT Control
REAR VIEW
OC
G B
A05295
Fig. 2 -- Wall Control Wiring
EBryant Heating & Cooling Systems 7310 W. Morris St. Indianapolis, IN 46231
Printed in U.S.A.
Edition Date: 12/05
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.
2
Catalog No. AG ---KVBCN---B01
Replaces: NEW
Download PDF