IEX-16L

IEX-16L
16 Channel Line Input Expander for myMix System
®
16 Balanced Line Level Inputs on two DB25 Connectors
®
Adds 16 Channels to myMix System in a 1U, 19-inch package
®
Independent Audio Channel Selection on every myMix unit
®
Convenient Signal Feed from a Mixing Console or External Microphone Pre-Amps
®
Individual Digital Gain Adjustment (0dB, +6dB, +12dB) per Input Channel
®
Can be combined with other myMix Input and Output devices
®
Configuration of IEX-16L from any myMix in the network or through the dedicated Configuration Port
®
Works with 100MBps Fast Ethernet Switches
®
Allows the Use of multiple IEX-16L with unlimited Audio Channels on Network*
®
Ethernet AVB ready (IEEE1722 protocol)
The IEX-16L is a 16-channel input expander for the myMix system. Equipped with two DB25 connectors, it allows the
connection of up to 16 balanced line-level signals that can be fed from devices such as mixing consoles or external
microphone pre-amps. IEX-16L and a single myMix unit can be connected without the need for a switch.
The IEX-16L can be configured through any myMix device on the network, including input channel naming and stereo linking.
IEX-16L inputs are available as named channels for every myMix in the network. Unused inputs can be disabled. The local
inputs on myMix units can be used in combination with the signals of any number of IEX-16L. If the total channel count is 16 (=
8 multicast pairs) or less a standard 100Mbs non-managed switch can be used. Each myMix can control a maximum of 16
channels by selecting 8 multicast pairs from available network channels, allowing the ability to tailor the unit to the specific
needs of each user. These pairs can be two dual mono, or one stereo signal. A network operating more than 16 audio
channels (8 multicast pairs) requires a switch that has IGMP snooping capabilities.
*The total number of audio channels on the network is dependent upon the capacity of the switch. Input signals are streamed in pairs as
multicast packets. A typical value is 256 multicast groups, which would allow 512 audio channels on the network.
System Integration
myMix connected to
the configuration port
(no audio)
Optional local inputs
on any myMix device
...
Individual line level signals, from
external pre amps or mixing console :
channel direct outputs and/or
submixes.
SWITCH
myMix and IEX-16L are connected to an Fast Ethernet switch. Inputs are fed to the system via IEX-16L and/or via the local inputs on myMix. For more than
16 audio channels on the network a managed switch with IGMP Snooping capabilities is required.
www.mymixaudio.com
IEX-16L
16-Channel Line Input Expander for myMix Systems
DIMENSIONS
483 mm (19")
44,4 mm
(1.75")
PINOUT DB25
432 mm (17")
145 mm
(5.71")
Ch1
Ch2
Ch3
Ch4
Ch5
Ch6
Ch7
Ch8
Hot
24
10
21
7
18
4
15
1
Cold
12
23
9
20
6
17
3
14
Grd
25
11
22
8
19
5
16
2
Channels 9 to 16 follow the same scheme. Compatible with
many third party audio snakes..
SPECIFICATIONS
Inputs
Input Impedance
Maximum Input Level
Input Gain Adjustment (digital)
Frequency Response
Signal to Noise Ratio
THD+N
Network
Network Type
Network Cabling
Network Connection
Network Switch for 16ch max.
Network Switch for > 16ch
Audio Channel Limit on Network
AD/DA Conversion
Input Connectors
Dimensions (W x H x D)
Net weight
Accessories
16
20 kΩ, balanced
+ 20 dBu
0dB, +6dB, +12dB
20Hz - 20 kHz (-1dB)
> 104dB
< 0,022%
100MBps Fast Ethernet
CAT5/CAT5e
2 RJ45, (1 network, 1 myMix)
unmanaged 100BASE-TX, Full-Duplex
managed 100BASE-TX, IGMP snooping (v2)
max of mulicast groups handeled by the switch x 2
24-bit, 48kHz
DB25 (8 channels) standard pin out
483 x 44 x 146 mm (19" x 1.75" x 5.")
2,7 kg (6 lbs)
external PSU for IEX-16L,
100V to 240V (50/60Hz)
E & OE. All specifications subject to change without prior notice.
myMix is a trademark of MOVEK, LLC. Patents Pending, all rights reserved by MOVEK LLC, USA.
www.mymixaudio.com