Epson | Stylus Photo 1500W | Installation Instructions for Epson Stylus Photo 1500W Continuous

Installation Instructions for
Epson Stylus Photo 1500W Continuous Ink System
List of Contents
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Continuous Ink System
Installation Manual
Tube Support Bracket
Spare Grommets
Spare Sticky Pads
Spare Rubber Seals
60ml Syringe
Sharp Needle
Screwdriver
Spare Plastic Elbows
Page | 1
Power on the printer and press the ink
button. When the carriage has moved to
the cartridge removal position unplug the
mains cable from the printer.
This allows the carriage to be moved
manually.
1
Move the carriage to the left, insert the
screwdriver into the hole and raise the
screwdriver to lever off the hinge. Remove
the cartridge lid.
Remove any cartridges from the machine.
Remove the centre bung from the rubber
seal.
BE CAREFUL NOT TO DAMAGE THE SEALS
WHEN REMOVING THE CENTRE BUNG
Repeat this for all colours, then place to
the right of the printer as shown.
NEVER PLACE THE BOTTLES HIGHER THAN
THE LEVEL OF THE PRINT HEAD
Page | 2
2
Move the carriage to the left hand side of
the printer.
Feed the cartridges under the printer
housing.
TAKE CARE NOT TO DAMAGE THE CHIP
RESETTER
Place the cartridges on the housing whilst
you move the carriage back to the
cartridge removal position.
Place the cartridges into the carriage. Press
them down firmly by spreading fingers
across all the cartridges.
Important:
ENSURE THAT EACH CARTRIDGE HAS
CLICKED INTO PLACE.
Page | 3
Remove the backing tape from the sticky
pads on the tube support bracket.
Position the bracket around the printer
button housing, ensuring the plastic tab
fits into the slot.
ENSURE THE SURFACE OF THE PRINTER
HOUSING IS CLEAN AND DRY
Place the tubes into the tube support
bracket and move the carriage all the way
to the left of the printer, remove any slack
by adjusting the tubes while in the support
bracket.
Remove the backing tape from the small
support bracket and fit as shown.
ENSURE THE SURFACE OF THE PRINTER
HOUSING IS CLEAN AND DRY
Attach the printer lid support brackets as
shown. You can now close the lid.
Page | 4
Plug in the mains power cable
and power on the printer.
The printer will go through the
initial ink charge before your
system is ready for use.
If the orange ink light is
illuminated when the printer is
powered on, press the ink button
to move the carriage to the
removal position.
Press and hold the chip reset
button for 5 seconds.
Press the ink button and the
printer will begin the initial ink
charge.
Page | 5
Your system is now ready for use.
Visit www.sawgrasseurope.com/technical-support for further instructions on how to
configure your Epson Stylus Photo 1500W for use with sublimation ink:
Setup should be completed in the following order:
1. Sublimation Installation Guide
2. Epson Driver Configuration
3. Printing from your graphics software application.
Page | 6
REFILLING THE BOTTLES
Lay the bottles down and remove the
rubber bung from the colour you wish to
refill.
Use the syringe and nozzle attachment
to fill the colour.
You cannot fill the reservoir further than
the hole allows.
Do not stand the system up so you can
fill the smaller chamber, this system
works on the principle that the smaller
chamber is partially empty.
Return the bottles to an upright position
and replace the rubber seal ensuring the
centre bungs are removed.
Page | 7
Download PDF