IQC600B
High Resolution IR Bullet Camera
650 TVL, 20m IR
USER MANUAL
TECHNICAL SUPPORT:
For Technical Support please contact your local distributor.
LIMITED WARRANTY:
This product is supplied with a 1 Year warranty. The Warranty excludes
products that have been misused, (including accidental damage) and damage
caused by normal wear and tear. In the unlikely event that you encounter a
problem with this product, it should be returned to the place of purchase.
Before you begin:
Please unpack the box carefully and identify that all the parts are present.
Make sure you use only the recommended power supply. Damage caused to
the camera by incorrect voltage or wiring is not covered by the warranty.
Do not cut the connectors of the camera cables, this will void your warranty.
Before operating this product, please read this instruction manual properly.
Caution
1.
2.
3.
4.
5.
6.
DO NOT ATTEMPT TO DISASSEMBLE THE CAMERA
HANDLE THE CAMERA WITH CARE
DO NOT EXPOSE AN INDOOR CAMERA TO RAIN OR MOISTURE, OR TRY TO OPERATE IT
IN WET AREAS - Take immediate action if the camera becomes wet. Turn the power off
to the camera and contact a CCTV professional. Moisture can damage the camera and
also create a danger of electric shock.
DO NOT USE STRONG OR ABRASIVE DETERGENTS WHEN CLEANING THE CAMERA BODY.
NEVER POINT THE CAMERA TOWARD THE SUN - Whether the camera is used outdoors or
not, never point it towards the sun. Use caution when operating the camera in the vicinity
of spot lights and light reflecting objects.
DO NOT OPERATE THE CAMERA BEYOND ITS TEMPERATURE, HUMIDITY OR POWER
SOURCE RATINGS. - Do not use the camera in an extreme environment where high
temperature of high humidity exists. Use the camera under conditions where
temperatures are between 14℉ to 122℉ (-10℃ to 50℃), and humidity is below 85%.
For the correct power supply, refer to the specification sheet.
2
Installation
1. Select a suitable position on the wall or ceiling to install the camera and
map out the holes for the bracket.
2. Drill a hole in the middle of area on the wall or ceiling where the
camera is to be mounted, to allow the power and video cable to be fed
through. Alternatively, the cable can be surface mounted by taking the
cabling out through the side of the bracket.
3. Screw the bracket base to the wall or ceiling using the Wall Plugs and
screws supplied.
4. To change the bracket position during installation, the different screws
on the bracket can be adjusted as shown in the diagram (A-D)
5. Connect the power terminal of the camera to a 12V DC regulated power
supply. Connect the camera video output and the video input on the
control or viewing equipment with RG59 (BNC) video signal cable.
12v DC Input
Power Cable
BNC
Video Cable
3
IQC600B
Specifications
Style:
Weather Resistant:
IP Rating
Operating Temperature:
Vandal Resistant:
Mounting Type:
Dimension:
Weight:
Warranty:
Sensor Type:
DSP Type:
DSP Functions:
IR Bullet Camera
Yes
IP65
-10 to 50°C
No
Wall or Ceiling
102 x 57 x 63mm (LxWxH)
0.31 Kg
1 Year
Xvision X650 - 1/3" Digital Imaging Sensor
Xvision XE
Automatic Electronic Iris
Automatic White Balance
Automatic Gain Control
650 TVL
0 Lux (IR on)
0.1 Lux (IR off)
20m IR Night Vision
True Day/Night (Mechanical IR Filter)
Fixed
3.6mm
78°
12v DC
280mA
BNC Socket
N/A
DC Socket
Resolution:
Minimum Illumination:
Night Vision:
Lens Type:
Lens Size:
Viewing Angle:
Operating Voltage:
Power Consumption:
Video Output:
Audio Output:
Power Input:
4
">
