IP Link® Device Interface
Ethernet Communication Sheet
eiki_1_4146_2.pkn
Revision: 10/25/2011
This document provides additional assistance with wiring your Extron IP Link enabled product to your device.
Different components may require a different wiring scheme than those listed below.
For complete operating instructions, refer to the user’s manual for the specific Extron IP Link enabled product or
the controlled device manufacturer supplied documentation.
Device Specifications:
Device Type:
Manufacturer:
Firmware Version:
Model(s):
Video Projector
Eiki
N/A
LC-XB26
Minimum Software and Firmware Requirements:
IP Link
Compiler
IP Link
Firmware
1.4.0
1.15
GC Version
3.2.0
Version History:
Driver
Version
Date
2
10/20/2011
Modified Maximum Lamp Hours Value for
GVE compatibility.
1
3/22/2010
Initial version.
Notes
Driver Notes:
Page 1 of 4
IP Link® Device Interface
Ethernet Communication Sheet
eiki_1_4146_2.pkn
Revision: 10/25/2011
Control Commands & States:
Aspect Ratio
16:9
4:3
Audio Mute
On
Off
Auto Image
Execute
Freeze
On
Off
Input
Component
Computer1 (A) RGB
Computer2 (A) RGB
DVI (HDCP)
DVI (PC)
S-Video
SCART
Video
Power Control
On
Off
Video Mute
On
Off
Volume (Discrete)
0 to 63 in steps of 1
Volume (Step)
Up
Down
Page 2 of 4
IP Link® Device Interface
Ethernet Communication Sheet
eiki_1_4146_2.pkn
Revision: 10/25/2011
Status Available:
Aspect Ratio
16:9
4:3
Audio Mute
On
Off
Connection Status
Connected
Disconnected
Device Status
Normal
Cannot Accept RS232C
Command
Power Fail
Power Save
Processing Power Save Cooling Down
Temp Warning (Power On)
Temp Warning and
Cooling Down
Temp Warning and
Recovered
Status Unavailable
Freeze
On
Off
Input
Component
Computer1 (A) RGB
Computer2 (A) RGB
DVI (HDCP)
DVI (PC)
S-Video
SCART
Video
Lamp Usage
Hours
Power Control
On
Off
Power Status
On
Off
Warming Up
Status Unavailable
Video Mute
On
Off
Volume (Discrete)
0 to 63 in steps of 1
Page 3 of 4
Cooling Down
IP Link® Device Interface
Ethernet Communication Sheet
eiki_1_4146_2.pkn
Revision: 10/25/2011
Network communication:
When configuring the Ethernet driver, be sure device settings match that of the GC configuration.
Port Type:
Ethernet
Logon Credentials
Supported:
Yes
Default User Name:
Default Password:
N/A
N/A
Default Port:
10000
Multi-Connection
Capable:
Undetermined
Port Changeable:
Undetermined
Ethernet Driver Configuration Description:
Notes for the Device:
The Eiki NPC - 1 network interface is required to be used to enable ethernet communication. Please refer to the
manufacturer for more information.
Page 4 of 4