PRINCO DDR3-1600 user guide and testing for ASRock-H55M

PRINCO DDR3-1600 user guide and testing
for ASRock-H55M-LE Motherboard
CPU i3-540 3.07G
Part I:Standard test
It’s the easiest way to enjoy overclock benefit by
using PRINCO DDR3-1600 DIMM board
How to use?
0. Clear BIOS to mainboard initial setting
1. Enter BIOS setup and [OC Tweaker] menu
2. Enter [Load XMP Setting] item and select [Profile #1]
BIOS will load X.M.P parameter in SPD on DIMM board,
which are performance optimized for PRINCO DDR3-1600
DIMM board
3. Enter [QPI Frequency] item and select [Auto]
4. Save BIOS changes [F10] and exit
Ps: after reboot , check if the new setup have been updated.
Test result?
In order to demonstrate the performance and stability of
PRINCO DDR3-1600 DIMM board, We use the strictest
stress testing, that is, multi-core MemTest in window 7.
(Data rate:799.6Mhz*2,
timing:7, 9, 7, 24,
multi-core test => pass!)
Advanced Overclocking and Testing
Part II:Heavy test
If you want to know the potential of PRINCO
DDR3-1600? Following are step-by-step howto.
How to use?
0. Clear BIOS to mainboard initial setting
1. Enter BIOS setup and [OC Tweaker] menu
2. Enter [Overclock Mode] item and select [Manual]
3. Select [BLCK Frequency] item,and increase to higher Base
clock rate (ex:180). Then select [DRAM Frequency] item,
and set the DDR3 memory to higher clock rate
(ex:DDR3-1800).
4.Don’t forget setting [CPU Ratio Setting] item to suitable
ratio [ex:16]
( In this case we only focus on memory over clocking, not CPU )
5. Select [DRAM Voltage] item , and set the value to
[1.600V].
6. Enter [DRAM Timing Control] item
7. set [DRAM tCL] item to [7]
set [DRAM tRCD] item to [9]
set [DRAM tRP] item to [7]
set [DRAM tRAS] item to [24]
set [DRAM Command Rate] item to [1]
8. Save BIOS changes [F10] and exit
Ps: after reboot , check if the new setup have been updated.
Test result?
We use the strictest stress testing, multi-core MemTest in
window 7, to show you PRINCO DDR3-1600 potential.
(Data rate:899.8*2, timing:7, 9, 7, 24,multi-core test => pass!)
Part III:Advance test
If you set parameter in BIOS as below ,
Overclock Mode:[manual]
BCLK frequency(Mhz) :[190]
CPU Ratio Setting:[16]
DRAM Frequency:[950Mhz DDR3_1900]
DRAM Voltage:[1.600V]
DRAM timing:9, 9, 9, 27
you can check next page
(Data rate:950.7*2=1900, timing:9, 9, 9, 27, multi-core test =>
pass!)