Equipex | PZ-4302D | Specifications | Equipex PZ-4302D Specifications

Operation Manual
For
Sodir
Pizza Oven– PZ-430S, PZ-431S, PZ-430D, PZ-4302D
765 Westminster Street  Providence, Rhode Island 02903  U.S.A.
Tel: (401) 273-3300
Fax: (401) 273-3328
www.equipex.com
e-mail: service@equipex.com
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed, including the
following:
1. Read all the instructions before use.
2. Do not touch hot surfaces; use handles or knobs.
3. To avoid electric shock, do not immerse the power cord, or any part of the unit, in any liquid.
4. Close supervision is necessary when any appliance is used, especially around children.
5. Unplug appliance from the electrical outlet when not in use, and before cleaning. Allow
appliance to cool before installing or removing any parts or accessories, and before cleaning.
6. Do not operate any appliance with a damaged cord or plug, or if appliance should sustain damage,
or malfunction in any way. In this event, return appliance to the nearest authorized service
facility for examination, repair or adjustment.
7. The use of accessories and/or attachments not recommended by the appliance manufacturer may
cause injury or damage to the appliance, and may void your warranty.
8. Do not use outdoors.
9. Do not allow the power cord to hang over the edge of a table or counter, or to be exposed to hot
surfaces, as damage may occur.
10. Do not place appliance on or near a burner, or in a heated oven.
11. To disconnect an appliance, first turn all controls to the ‘off’ position; then unplug the power
cord from the wall outlet.
12. Do not use appliance other than for its intended use.
13. SAVE THESE INSTRUCTIONS FOR LATER USE!
INTRODUCTION
The SODIR model PZ-430S, PZ-431S, PZ-430D and PZ-4302D pizza ovens are designed for
quality baking of fresh, frozen or par-baked pizza in just 3-6 minutes. The ovens are constructed
of food service quality stainless steel, and are equipped with separately adjustable top and
bottom rows of fast-heating infrared quartz elements, which allow perfect fine tuning of the
baking dynamics. The units are thermostatically controlled up to 660o F by a top thermostat and a
15-minute timer plus a constant on position. In addition, the bottom quartz elements are controlled
by a bottom thermostat, also with a constant-on position, to allow adjustment of the heat intensity
going to the brick, which permits perfect baking of different crust types. Two indicator lights, green
and orange, indicate power and heating respectively. Units include a baking stone, affording
brick-oven flavor and quality. All models will fit a 16” pizza, except for the PZ-4302D, which will
fit up to a 16” x 24” rectangular pizza, or several personal size pizzas. The interior light allows you to
check progress through the glass window, allowing the chamber to remain closed. Both chambers of
the PZ-430D dual oven are independently controlled. Steam is vented from the oven chamber
through the steam tube in the rear wall.
Specifications:
Model
Electrical
Plug Configuration
PZ-430S
120V, 1 PH, 1.8KW, 15A
NEMA-5-15P
PZ-431S
208/240V, 1PH, 3.4KW, 13/15A
NEMA-6-20P
PZ-430D
208/240V, 1PH, 7.2KW, 26/30A
NEMA-6-50P
PZ-4302D
208/240V, 1PH, 5.7KW, 21/24A
NEMA-L6-30P
INSTALLATION
The SODIR pizza oven needs to be connected to a grounded outlet of proper voltage,
208/240V or 120V, depending on the model. DO NOT place the unit in a damp area or near
steam sources. Make sure that the exterior rear ventilation panel is not blocked. Maintain 4”
clearance at each side, rear and top of the oven.
ASSEMBLY
Your SODIR pizza oven comes from the factory fully assembled, with the pizza stone
shipped on top. The ovens are shipped with plastic exterior protective film, which must be
removed before operation. DO NOT operate the oven prior to removing the protective film
completely! Clean the unit thoroughly, inside and out, using a soft cloth dampened with a
solution of soap and water, before first use. DO NOT allow the pizza stone to get wet!
Place the pizza stone gently in the bottom of the oven, over the infra-red quartz tubes.
OPERATION
Preheating
To preheat the pizza oven, select the temperature by rotating both thermostat knobs clockwise
to the desired setting and then turn the timer knob, which is also the ON/OFF switch,
counter-clockwise to the constant-on position. Both indicator lights (green and orange or
red) will be lit. The orange or red light will stay on until the oven reaches the desired
temperature, and then cycle on and off. The green light will stay on until the timer expires.
Allow about 20 minutes for the preheating process.
Cooking
After the preheat process is completed, select the desired temperature on the top thermostat
and set the bottom thermostat (1-9 setting + constant on position). Turn the timer knob to
select the time setting on the 15-minute timer. When the set time has elapsed, the heating
elements will turn off, the indicator lights will go out and the timer bell will chime,
announcing the end of the cycle. To use the oven in continuous mode, turn the timer knob
counterclockwise to the position marked by the hand pictograph. Cooking time will vary
depending on toppings, crust thickness, temperature settings and desired results, but is
generally between 3 and 6 minutes.
The bottom thermostat is also controlled by the top thermostat. The bottom heating elements
will never be on when the top elements are off. For thin crust pizza, the bottom thermostat
should be set at a high setting (recommendation: 8 or 9), or in the ‘C’ constant on position.
For thicker crust, the bottom thermostat should be set lower (recommendation 6 or 7), to allow
slower and continual cooking of the crust. While designed for superior cooking of pizza,
other products, such as calzones, quiches, pies, breads and pastries may also be cooked in
your pizza oven.
Cleaning
WARNING: Disconnect (unplug) electrical power supply before cleaning
Cleaning is a very important part of maintaining a safe and well working machine. Allow the
oven to cool before cleaning. Remove the pizza stone while it is still slightly warm and gently
scrape off any residue. You may use a soft wire brush to gently rub any trouble spots. Use a
cloth dampened slightly with a soap and water mixture to clean all exterior and interior
stainless steel surfaces, being careful of the quartz tubes as they are fragile. Use a clean lintfree cloth to remove the excess water or soap. Make sure no water enters the unit through
ventilation holes.
DO NOT use an abrasive sponge on exterior or interior surfaces
DO NOT wash the oven under running water
DO NOT spray the exterior housing with any liquid
DO NOT allow water to drip into the motor housing or onto electrical components
Maintenance
You should inspect all parts on a regular basis to ensure that all is in proper working order. If a
part is damaged, have the unit repaired by an authorized service agency prior to returning the
unit to operation. If you have trouble locating a service agency in your area, please consult our
website at http://www.equipex.com/, or call us at 1-800-649-7885 and ask for customer service.
Spare Parts PZ-430S and PZ-431S
Ref
Part # Qty
Description
1
35101
1
Left deflector
2
D04041
2
Rear top quartz tube+heating element
3
D04040
2
Front top quartz tube+heating element
4
35087SE
1
Control panel
5
D04041
4
Bottom quartz tube+heating element
6
F07025
1
Fire stone
7
A08009
1
Green pilot light
8
35113
12
Against weight
9
35095SE
1
Door
10
35096SE
1
Inner door
11
H01076
2
Glass
12
A15061
1
Handle
13
A08003
1
Orange pilot light
14
A13017
4
Foot
15
A14078
3
Knob
16
35091
1
Top
17
B04104
1
Steam tube
18
A18022
1
Lamp + lamp holder
19
A16013
1
Terminal block
20
35100
1
Tank back rear
21
35102
1
Right deflector
22
C03013
1
Cord with plug
23
A10032
1
Cord closer
24
35099
2
Side casing
25
35088
1
Base
26
A02029
1
Timer 15 '
27
A06042
1
Thermostat
28
A04006
1
Regulator
Spare Parts PZ-430D
Ref # Part #
Qty
Description
1
35111
1
Left deflector
2
D04041
4
Rear top quartz tube+heating element
3
D04040
4
Front top quartz tube+heating element
4
35106SE
1
Control panel
5
D04041
8
Bottom quartz tube+heating element
6
F07025
2
Fire stone
7
A08009
2
Green pilot light
8
A13017
4
Foot
9
35113
24
Against weight
10
35095SE
2
Door
11
35096SE
2
Inner door
12
H01076
4
Glass
13
A15061
2
Handle
14
A14078
6
Knob
15
35091
1
Top
16
B04104
1
Steam tube
17
A18022
2
Lamp + lamp holder
18
A16014
1
Six position terminal block
19
35110
1
Tank back rear
20
35112
1
Right deflector
21
C03013
2
Cord with plug
22
A10032
2
Cord closer
23
35109
2
Side casing
24
35088
1
Base
25
A08003
2
Orange pilot light
26
A02029
2
Timer 15 '
27
A06042
2
Thermostat
28
A04006
2
Regulator
Spare Parts PZ-4302D
Ref # Part # Qty
Description
1
35124
1
Left deflector
2
D04039
2
Rear top quartz tube+heating element
3
D04038
4
Front top quartz tube+heating element
4
35114SE
1
Control panel
5
D04039
4
Bottom quartz tube+heating element
6
F07024
1
Fire stone
7
A08009
1
Green pilot light
8
35113
12
Against w eight
9
35119SE
1
Door
10
35120SE
1
Inner door
11
H01075
2
Glass
12
A15060
1
Handle
13
A08003
1
Orange pilot light
14
A13017
4
Foot
15
A14078
3
Knob
16
35116
1
Top
17
B04104
1
Steam tube
18
A18022
1
Lamp + lamp holder
19
A16014
1
Six position terminal block
20
35123
1
Tank back rear
21
A05008
1
Contactor
22
35125
1
Right deflector
23
C01010
1
Cord
24
A10032
1
Cord closer
25
35099
2
Side casing
26
35115
1
Base
27
A02029
1
Timer 15 '
28
A06042
1
Thermostat
29
A04006
1
Regulator
LIMITED WARRANTY
Your new EQUIPEX product is warranted to the original purchaser for a period of one year from the date of purchase.
This limited warranty is against defects from original factory imperfections in material and/or workmanship
and includes labor for replacement of defective parts, provided repairs are performed by an authorized service
agency. Our obligation under this warranty is limited to repairing or replacing any part or parts thereof. The
CUSTOMER must inform the Service Agency of warranty coverage and provide a copy of the dated sales or
delivery receipt BEFORE WARRANTY REPAIRS BEGIN. Replacement parts and accessories are warranted for
ninety (90) days from the date of purchase when purchased separately and will be verified by dated sales receipt or
packing slip for that item. All parts or accessories replaced under warranty must be returned to the Service Agency.
This warranty applies only to equipment under normal use and service in the U.S.A. and Canada. It does not
apply to any item which has been repaired or altered in any way so as, in the judgment of EQUIPEX, to affect its
reliability.
THE FOLLOWING ARE NOT COVERED UNDER WARRANTY:
1.
Damage caused by abuse, misuse or dropping or other similar incidental damage caused by, or as a
result of, customer failure to follow assembly, operation, cleaning, user maintenance or storage
instructions.
2.
Labor to replace inoperative parts such as bulbs, plugs or racks due to normal wear and tear or abuse.
3.
Materials or labor to repair scratched, stained, chipped, pitted, dented or discolored surfaces, attachments or
accessories.
4.
Transportation charges to or from a service agency for repair of your machine. If you should have
questions relating to this issue, please call Equipex at 1-800-649-7885.
5.
Labor charges to install or test attachments or accessories, which are replaced for any reason.
6.
SHIPPING DAMAGES. Visible and hidden damages are the responsibility of the freight carrier.
The consignee must file the claim promptly against the carrier.
KEEP ALL ORIGINAL
CONTAINERS AND PACKAGING MATERIAL FOR CARRIER INSPECTION.
7.
Products placed or stored in the equipment are not subject to this warranty and no responsibility is
assumed thereof.
THIS WARRANTY IS GIVEN EXPRESSLY AND IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED
OR IMPLIED, FOR MERCHANTABILITY AND FOR FITNESS TOWARD A PARTICULAR PURPOSE AND
CONSTITUTES THE ONLY WARRANTY MADE BY EQUIPEX, LLC. IT NEITHER ASSUMES, NOR AUTHORIZES
ANY PERSON TO ASSUME FOR US, ANY OTHER LIABILI TY IN CONNECTION WITH THE SALE OF THE
SUBJECT EQUIPMENT.
For service, please call EQUIPEX at 1-800-649-7885, menu option # 3
765 Westminster Street  Providence, Rhode Island 02903  U.S.A.
Tel: (401) 273-3300
Fax: (401) 273-3328
www.equipex.com
e-mail: service@equipex.com
Download PDF