brigii MX30 Cordless Pet Hair Vacuum User Guide

MX30
Dust Cup
Filter
Multi-Surface Tool
Indicator
On-Off
Machine
Charging Port
Air Outlet
2 In 1 Brush Nozzle
Type-C Charging Cable
Base
Notice: Do not use the vacuum while charging. Please disconnect the
charging cable before using it.
Please fully charged before first use!
OPERATION AND DISPLAY STATUS
Operation
Press the
power button
Press the power
button
Vacuum status
Indicator Status
Working properly
Solid white light
Low power
Red light flashes and
stops blinking
Stop working
The indicator went out
Charging
Red light blinking
Fully charged
Solid white light
Charging
TROUBLESHOOTING
Condition
Won't charge
Won't turn on
Reasons
Solutions
Not connecting the power
supply correctly
Please check the power supply and
charger block and connect them
correctly
Overheating of the vacuum
or surrounding
Low-temperature of the
vacuum or surrounding
Please stop charging, let it sit for 15
minutes and charge it again after
reaching the room temperature
（Please use, store and charge it
within an ambient temperature of
0°C(32°F)-40°C(104°F)）
Out of power
Please charge before use
Cable connected
The vacuum cannot be turned
when the cable is connected to the
power supply.
Blockage caused
thermal cut-out
Please follow the instructions to
clean the dust cup and filter before
use.
Won't turn on
Overheating of the vacuum
or surrounding
Low-temperature of the
vacuum or surrounding
Please stop using it, let it sit for 15
minutes and charge it again after
reaching the room temperature
(Please use, store and charge within
an ambient temperature of
0°C(32°F)-40°C(104°F))
Abnormal Noise
when using
Incorrect filters were
installed and foreign
objects sucked
Turn off the power, try to take out
the objects and install the filter
correctly
The dust cup is full
Air inlet or filter be clogged
Clean the air inlet and dust cup on
time according to the instructions or
change the filter on time
Low battery
Please fully charge before use
Suction decreased
Please contact Brigii customer support team, if your problem still cannot be
solved.
Official website： www.brigii.com
Email：[email protected]
CLEANING AND MAINTENANCE
The suction power and battery life may decrease if the filter is clogged,
please clean the filter in time or change the filter.A good rule of thumb
is to change your high performance filter every 3 months.
Do not wash the motor housing.
1.Rotate the dust cup in the direction of the arrow to open it and remove the
filter assembly. Then disassemble the HEPA filter.
2.Wash the filters and dust cup, air-dry them completely and reassemble the
filters.
More languages
Deutsch
Français
Italien
Español
中文
中文繁體
한국어
www.Brigii.com