User guide for
Kamstrup OMNIA® e-meter
The Meter constant LED blinks (yellow) at
a rate of 1000 blinks per kWh of imported
electricity.
The Supply switch LED blinks (red) when the
internal supply switch is disconnected. To
reconnect, press and hold the Control button
for 3 seconds.
If the LED is constantly lid, the supply switch
is disconnected by your electricity distributor.
In that case, contact customer service.
HAN
[RJ12]
How to read your
electricity consumption
from the display
The value shown in the
display is identified by
an OBIS code in the top left corner.
Typical examples:
• 1.8.0 is the electricity imported from the
electricity grid (in kWh).
• 2.8.0 is the produced electricity (ex. from solar
panels) exported to the electricity grid (in kWh).
• 1.7.0 is the electrical power imported right now
from the electricity grid (in kW).
• 2.7.0 is the produced electrical power exported
right now to the electricity grid (in kW).
• 3.8.0 and 4.8.0 is the so-called positive and
negative reactive energy (in kvarh).
• A digit other than ‘0’ in the third location
indicates that the shown value represents a
specific tariff.
You can connect your own compatible
smart home equipment directly to the HAN
interface using a suitable cable.
The HAN interface is a one-way data channel
from the meter to the equipment you
connect.
Your electricity distributor must enable the
interface before you can use your smart
home equipment. This can often be done
from remote.
In some countries, press and hold the Control
button for 3 seconds to disconnect the
electricity supply to the home.
To reconnect, press and hold the button again
for 3 seconds.
Press the Menu button to change the display.
After 2 minutes, the display reverts
automatically to show (1.8.0) electricity
imported from the grid.
Some meters alternate between showing
(1.8.0) electricity imported and (2.8.0)
electricity exported.
Kamstrup A/S • FILE100002337_B_EN_2023-06
">
