INTEGRATED HEADREST
CATALOG NO. F-422PLH-2
USE THIS MANUAL FOR ALL
AQUA CREEK PRODUCTS' ACCESS LIFTS
MANDATORY
LEAVE THIS MANUAL WITH OWNER
Read and follow all instructions.
Lift safety can only be ensured if the
headrest is installed and operated
according to these instructions.
• FOR SAFETY REASONS
• NEVER swim alone
• NEVER use the lift with a dry pool
• NEVER apply direct water pressure to the electronics
• NEVER permit children to play on or around the lift
• DO NOT allow children to use the lift without adult
supervision
READ CAREFULLY
Check entire box and all packing
materials for parts. Before beginning
assembly, read the instructions and
identify parts using the figures and
parts listed in this document.
It is critical that all parts be carefully
inspected prior to installation. If any
damage occurred in transit, Aqua Creek
Products, LLC must be notified within
three days of receipt of unit.
Proper installation cannot be
overstressed, as an improper
installation voids Aqua Creek’s warranty
and may affect the safety of the user.
Aqua Creek Products, LLC
9889 Garrymore Lane
Missoula, MT 59808
Toll Free: (888) 687-3552
Local/Intnl: (406) 549-0769
www.aquacreek.com
11/30/2022 1:49:29 PM PAGE - 1
Aqua Creek Products
PRODUCT COMPONENTS
3
1X
2
1X
5
4X
7
2X
6
2X
4
2X
2
1X
1
1X
ASSEMBLY - HEADREST - INV01455
ITEM
PART NO.
QTY.
REV.
DESCRIPTION
1
INV00854
1
P1
LASER/WJ - HEADREST SEAT BRACKET
2
INV00855
1
P1
LASER/WJ - HEADREST ADJUSTMENT BRACKET
3
INV00806
1
P1
HEADREST PAD
4
INV01181
2
N/A
NW - 1/4"-20 WING NUT
5
INV01170
4
N/A
WF - 1/4" FLAT WASHER
6
INV01182
2
N/A
WL - 1/4" LOCK WASHER
7
INV00341
2
N/A
BOLT - BHSCS 1/4"-20x1"
11/30/2022 1:49:29 PM PAGE - 2
Aqua Creek Products
PRODUCT ASSEMBLY
1. If the headrest pad has not yet been installed, install it first. The pad height may
be adjusted now, or afte the assembly has been attached to the chair. Assemble
fully as shown in FIGURE 01.
2. Slide the support bracket into the slots on top of the seat. FIGURE 02
The Integrated Headrest assembly is now ready to adjust and use.
PUT IN LOOPS FIRST
HOOKS & LOOPS
(PRESS TOGETHER)
HEIGHT
ADJUSTMENT
HEADREST
UP
HEADREST
DOWN
(SHOWN IN LOWEST
POSITION)
FIGURE 01
NOTE: The INTEGRATED HEADREST
ASSEMBLY will work on all 2nd
generation 18” wide Aqua Creek
Products’ chairs*. The 18” chair comes
standard on all Aqua Creek Products’
access lifts.
*(The 2nd generation 18” wide chair has
the slots for the INTEGRATED
HEADREST, where the 1st generation
18” wide chair does not).
FIGURE 02
11/30/2022 1:49:29 PM PAGE - 3
">
