ALPHA-60M MINI HIGH PERFORMANCE CCD BARCODE

ALPHA-60M MINI HIGH PERFORMANCE CCD BARCODE SCANNER MODULE
¤@
¡ B
Introduction
Alpha-60M is ZEBEX brand new design high performance in an ultra-small
package barcode scanner module.ALPHA-60M use 3000 pixel 7*200 micro meter
high density CCD array and Ultra-short focal length optic system, which
remarkably enhance CCD receiving efficiency.and easy to integrate into your new
equipment design.
Alpha-60M uses popular multi-interface including keyboard wedge, C-MOS series,
RS-232C series, Wand emulatior etc.
The user can change the scanner to
another interface simply by replacing the cable and reconfiguration to a specific
communication setup.
The scanner remains in the last interface mode whenever the scanner is reset.
The user ought to scan the emulation keyboard type e.g. IBM AT or RS-232C or
Wand Emulation label and specific parameter labels to operate the scanner
properly if the intends to use another interface mode.
The other hand for RS-232 user’ s, the device configuration can be changed by
receiving command from the Host through the serial interface.
¤G
¡ B
SPECIFICATIONS
TYPE OF KEYBOARD EMULATED
OPTICAL
Optics System
3000 Pixels CCD
IBM PC/XT/AT, IBM PS/2 Model 30-80, IBM
Resolution
0.1mm(4mil)
5550, 5530-SC, 5530-ZC, IBM 3196, 472/3477,
5395 Terminal, NEC 9801, Apple MACII and
Min. PCS Value
30°
Light Source
Visible LED
more............
(Wave length 660nm)
READABLE CODES
Scanning speed
160 scans/sec
Code 39, Full ASCII Code 39, Interleaved 2 of
Reading distance
25mm(EAN*1, PCS =90%)
5, UPC A, UPC E, EAN/JAN 8, EAN/JAN 13,
ISBN/ISSN, Code 128, Code 93, Codabar,
Chinese post code, IATA, MSI, Plessy,
ELECTRICAL
Supply Voltage
5VDC±5%
EAN-128, Code 32
Operating Current 100mA typical
OPTION:STD 2 of 5, Matrix 2 of 5, Code 11
ENVIRONMENT
PROGRAMMABLE CHARACTERISTICS
Operating Temp.
0°C~40°C
BUILT-IN DECODER:
Storage Temp.
-20°C~60°C
Type of Interface
Humidity
20% RH TO 85% RH
Code Type Selection, Check Digit Selection
(non-condensing of dew)
Decoding Option
Transmitted Character Delay
Header Selection, Trailer Selection
MECHANICAL
Cable Length
Straight
Good Read Beep Tone
Weight
45g (1.6 oz) exclude cable
Bar-code Identifier
Case Material
Without case
External I/O trigger or command trigger
KEYBOARD EMULATION TYPE:
MULTI-INTERFACE
Inter-message Delay, Keyboard Type and
Keyboard Emulation, C-MOS Serial and Wand
Keyboard Language
Emulation all in one units.
SERIAL INTERFACE TYPE:
ACK/NAK, Xon/Xoff, RTS/XTS, BAUD RATE,
DATA BIT, SOTP BIT, PARITY
Via RS-232C command programmable
¤T
¡ BPIN Definition for ALPHA-60M
PIN 6
PIN 1
PIN 1
PIN 6
CN1
CN2
CN1
1
2
3
4
5
6
Wire color
DESCRIPTION
color
Black
PC data (for keyboard wedge)
brown
PC Clock (for keyboard wedge)
Red
+5V
Orange
GND
Yellow
KB Clock (for keyboard wedge)
Dark green KB data (for keyboard wedge)
CN2
1
2
3
4
5
6
Wire color
Blue
Purple
Grey
White
pink
green
DESCRIPTION
CTS, Clear to send control line
TX, Serial data transmit to the host
GOOD READ OUTPUT SINGAL(C-MOS OUTPUT)
Trigger input, A low level on this input bar code
scanning
RX, serial data received from the host
RTS, Request to send control line
NOTE 1: CN1 and CN2 is JAM 6 pin 1.0mm pitch wafer.
¥|
¡ BAlpha-60M Mount and decode Zone diagram