Amazon | BFB-3000 | Replace a hot end (BFB

BFB 3000
Replacing the Hot End
Document No: D100252
Page: 1
BFB 3000 – Replacing the Hot End
Disassemble Extruder 1 and 2
Unscrew the pressure bearings and cut the
material to detach from the extruders.
Unscrew and remove the fans.
Document No: P100010
Page: 2
BFB 3000 – Replacing the Hot End
Unscrew and remove the Loom.
Disconnect the motors found at the back of
the printer.
Mark the position of the sensor switch
before unscrewing and detaching.
Set to 10mm when you re-connect
Document No: P100010
Page: 3
BFB 3000 – Replacing the Hot End
Disconnect the fans and unscrew the fan
connector.
Unscrew the extruder from the X carriage
bearing.
Continue to unscrew the extruder plate
from the X carriage bearing.
Remove the Perspex arm.
Document No: P100010
Page: 4
BFB 3000 – Replacing the Hot End
Unscrew the m3 x 16 cap screw which fixes
the PTFE tube
Unscrew and detach the motors
Unscrew and detach the motor plate
Document No: P100010
Page: 5
BFB 3000 – Replacing the Hot End
Unscrew and detach the first extruder
Unscrew and detach the hot end.
Replace the hot end and re-assemble the
extruder.
Document No: P100010
Page: 6
BFB 3000 – Replacing the Hot End
Attach the motors back onto the plate.
Re-attach the sub-assembly to your printer in
the reverse order that it was removed.
NOTE: When refitting the sensor switch, be careful not to over tighten the fixing screw and position at
10mm length.
On completion of the assembly, reset the bed level and Z height using the functions found in the ‘Settings’
menu.
Document No: P100010
Page: 7
Download PDF